Kenmore Dishwasher 665.13873K600 (66513873K600, 665 13873K600) Parts
Genuine Whirlpool part
By: Whirlpool
Part Number: WP8564929
Color: gray. It measures about 1-1/2 inches in diameter.
Do-It-Yourself Stories from Customers like You
Missing rinse aid cap in dishwasher Thomas A. • Portland , PA • November 29, 2014
I bought a new home and with it came a Jenn-Air dishwasher. I noticed after using the appliance and filling the rinse aid container that where was no cap to hold/seal the rinse aid within the appliance or anywhere to be found. I was missing.! I was going to call Jenn-Air to inquire about this part, instead I searched online first and found it at Appliance Parts Pros.com. I ordered the part, it arrive to my home in less then 2 days and it fit! This is the easiest repair I've ever done and...
Read more
More
$27.37
- Compare At:
-
$32.57
- You Save:
-
$5.20
Genuine Whirlpool part
By: Whirlpool
Part Number: WPW10247512
This upper dishrack track mounts to the dishwasher tub wall and provides a smooth glide path for the rack rollers. Replacing a damaged track restores easy in-and-out movement and helps keep the upper rack aligned and secure.
- Guides and supports the upper dishrack as it slides in and out
- Maintains rack alignment to prevent binding or derailing
- Typical failure signs: rack jams or falls off, rough/squeaky travel, visible cracks or breaks in the track
- Can keep the rack from fully sliding in, making the door harder to close
Install notes:
- Disconnect power and turn off the water supply before servicing
- Remove the upper rack by releasing the end caps/stops
- Unfasten the old track from the tub (screws/clips), then position and secure the new track
- Reinstall the rack and end caps; verify smooth rack travel before restoring power and water
Do-It-Yourself Stories from Customers like You
The rollers on the upper track of dishwasher broke tracks would not work correctly Ralph N. • Dover , NJ • May 26, 2015
Ordered tracks and adjusters via chat. Adjusters were not needed so I returned them. The repair was very easy. Had to slide out the dishwasher and remove four screws holding each track. Installed new tracks and put dishwasher back in place.
Read more
More
$117.56
- Compare At:
-
$139.90
- You Save:
-
$22.34
Genuine Whirlpool part
By: Whirlpool
Part Number: 4396840RC
The dishwasher rack repair kit provides components to fix damaged dish racks, including replacement wheels, tines, and clips. Use this kit when rack wheels break, tines bend or snap off, or the rack becomes difficult to slide in and out smoothly.
More
$57.39
- Compare At:
-
$68.87
- You Save:
-
$11.48
Genuine Whirlpool part
By: Whirlpool
Part Number: 4392899
Touch-up paint for appliances. Covers chips, scratches, and worn areas on range tops, refrigerators, and other appliances. Includes brush applicator.
Do-It-Yourself Stories from Customers like You
Lack of accurate control on 2 electric range burners Jeff D. • Neenah , WI • April 09, 2016
Ordered 2 infinite burner controls from Appliance Parts Pros and watched the online video on the replacement of them at the same time. When they arrived promptly, I was ready to take on the job.
The fix only took about 15 minutes because I was prepared after watching the video.
Read more
More
$18.23
- Compare At:
-
$21.88
- You Save:
-
$3.65
Genuine Whirlpool part
By: Whirlpool
Part Number: WPW10073520
Foam pad that installs between dishwasher door panels to dampen sound and shield from heat. Replace if torn, compressed, or missing for quieter operation.
More
$50.57
- Compare At:
-
$60.18
- You Save:
-
$9.61
Genuine Whirlpool part
By: Whirlpool
Part Number: 4396838RC
White dishwasher rack repair kit includes 150 tine tips and vinyl paint to cover chipped, rusted, or worn rack tines. Extends rack life and prevents rust.
Do-It-Yourself Stories from Customers like You
Old rusty lower dishrack tines John N. • Alamogordo , NM • January 11, 2016
Replaced it with the modern replacement you provided. Now I have a repair kit, spare rollers, a foldable rack of tines and all the related parts put back for repair if necessary. A win win scenario. Thanks for all you do. :>)
Read more
More
$52.95
- Compare At:
-
$63.54
- You Save:
-
$10.59
Genuine Whirlpool part
By: Whirlpool
Part Number: WPW10334457
Fix a dishwasher motor that hums or won't start. This run capacitor provides the phase shift needed for smooth motor operation. DIY repair in 30-45 min.
Do-It-Yourself Stories from Customers like You
Dishwasher would start begin to fill with water then there would be 4 5 short "hums" or "buzzes" it would then shut off and drain what water had filled John S. • Granite Falls , MN • September 19, 2017
Figured it was either the capacitor and/or motor. Ordered both parts to be sure. tried changing the capacitor first; same problem. Replaced the motor (leaving the new capacitor in place). Unit now works fine. Overall an easy fix once you get the washer out and tip it on its side or top to get access to the motor area.
Read more
More
$87.43
- Compare At:
-
$104.92
- You Save:
-
$17.49
Genuine Whirlpool part
By: Whirlpool
Part Number: WPW10508676
Secures water inlet tubing to create a leak-resistant seal. Replace if cracked, stripped, or unable to hold the line securely. Confirm fit with your model.
Do-It-Yourself Stories from Customers like You
Leaking Larry J. • Edison , NJ • March 07, 2021
I bought the part from AppliancePartsPros.com. Removed water inlet hose. Removed water outlet hose. Removed water inlet valve which was held on with one screw. Replaced the water inlet value. Reattached both hoses. It leaked a little bit, so I had to put plumbing tape and really make it tight. Then the leaked stopped.
Read more
More
Genuine Whirlpool part
By: Whirlpool
Part Number: WP3400892
Replacement 8-32-thread screw used to secure panels, brackets and small components in compatible household appliances. Restores missing or stripped fasteners so panels and parts stay firmly attached during normal use. What it does:
- Secures trim, panels, brackets and control housings to maintain proper assembly.
- Replaces missing or damaged screws that can cause rattling, loose panels or misaligned components.
- Fits locations that require an 8-32 threaded fastener; correct length and head style for your application.
- Helps restore stable, vibration-free operation when worn or stripped fasteners are replaced.
What's included: One screw. Install notes:
- Disconnect power and water before servicing; wear eye protection and gloves.
- Use the correct screwdriver or driver bit to avoid stripping the screw head.
- Do not overtighten—turn until snug and secure to avoid damaging threads or surrounding parts.
- If the original used a washer or nut, reuse or replace as needed and the screw length and head type match the original.
More
$5.95
- Compare At:
-
$7.14
- You Save:
-
$1.19
Genuine Whirlpool part
By: Whirlpool
Part Number: WP8572611
Also order air vent gasket
Do-It-Yourself Stories from Customers like You
Excess steam release caused leaking down the front of the dishwasher John F. • Chester , NJ • August 02, 2015
Replaced Air Vent (+gasket). (Based on some googled descriptions of how.)
Took out several screws in the vicinity of the vent on upper left of door. These are specialized torx screw heads. Released inner panel enough for air vent to slide out. It is held to the panel by the louvered round cover. Twist the cover to the left to remove it and the Air Vent comes loose.
I tested the resistance of the old Air Vent and found it to be ~18 ohms. I had found on one site that it should be between 6 and...
Read more
More
$106.38
- Compare At:
-
$126.59
- You Save:
-
$20.21
Genuine Whirlpool part
By: Whirlpool
Part Number: 8193716
This adjustable leveling leg threads into the appliance base to set height and stabilize the cabinet. Replacing a worn or missing leg helps stop rocking and vibration and helps maintain proper alignment for reliable operation.
- Provides adjustable support at one corner of the appliance
- Helps level the unit for correct alignment with floor or cabinetry
- Reduces rocking, vibration, and rattling noises
- Replaces stripped, bent, cracked, or missing leg
What's included: 1 adjustable leveling leg Install notes:
- Disconnect power and, if applicable, shut off water before servicing
- Carefully support or brace the appliance to access the base safely
- Start the new leg by hand to avoid cross-threading; adjust height gradually
- Use a level to check side-to-side and front-to-back, then recheck after positioning
More
$48.46
- Compare At:
-
$57.67
- You Save:
-
$9.21
Genuine Whirlpool part
By: Whirlpool
Part Number: WP3400071
10-32 thread machine screw secures panels, brackets, and internal components. Replace missing, stripped, or damaged fasteners to restore solid fit.
More
$5.95
- Compare At:
-
$7.14
- You Save:
-
$1.19
Genuine Whirlpool part
By: Whirlpool
Part Number: WP8535086
Top rack spray arm that rotates to distribute water across upper dishes. Replace if cracked, broken, or not spinning freely to restore water coverage.
Do-It-Yourself Stories from Customers like You
Top rack dishes had a grainy deposit and were not getting cleaned properly Gella S. • Leola , PA • February 14, 2016
I discovered that the water inlet manifold was cracked. Installed the new part which greatly improved the issue but was not completely resolved. Upon further inspection it looked like the arm bearing had seen better days so, since the machine is ten years old I opted to replace the rest of the assembly. Parts came in a timely manner and the repair was easy - top rack dishes are now spotless!
By the way I am a fifty something female with no prior dishwasher repair experience -...
Read more
More
$59.48
- Compare At:
-
$70.78
- You Save:
-
$11.30
Genuine Whirlpool part
By: Whirlpool
Part Number: 285006
Color: Black. Size: 12 oz. Acrylic appliance aerosol can spray paint.
Do-It-Yourself Stories from Customers like You
My 1984 dishwasher that still works great was an eyesore & I didn't match my other appliances. Dorothy L. • Raleigh , NC • March 24, 2014
I purchased a can of black appliance spray paint, removed the panels on the dishwasher, sprayed them, and a few hours later put them back. They're beautiful and it looks like I have a brand new dishwasher! It now matches everything and looks great with the new granite counter tops I just installed. THANK YOU FOR THE GREAT IDEA!!! I'm a 76 year old female and my friends think I'm a genius!
Read more
More
$42.95
- Compare At:
-
$51.11
- You Save:
-
$8.16
Genuine Whirlpool part
By: Whirlpool
Part Number: WPW10348407
Factory #10-16 screw secures dishwasher panels, brackets, and covers. Replace worn, stripped, or missing screws to restore tight assembly.
Do-It-Yourself Stories from Customers like You
Some accessories were worn. Wayne C. • Massapeqau Park , NY • April 15, 2020
My son fixed the issue of some wear and tear.
Read more
More
$5.95
- Compare At:
-
$7.08
- You Save:
-
$1.13
Genuine Whirlpool part
By: Whirlpool
Part Number: W11240750
Organizes cutlery in your dishwasher's lower rack. Replace if cracked, broken, or missing. Separates silverware during wash cycles for better cleaning.
More
$30.95
- Compare At:
-
$36.52
- You Save:
-
$5.57