Kenmore Dishwasher 665.15721690 (66515721690, 665 15721690) Parts

Secures knobs, trim, or linkages to shafts inside your dishwasher. Replace if broken, cracked, or missing to prevent components from loosening.

This is a gray plastic or metal channel that holds the door gasket in place along the edge of the dishwasher door or tub. It keeps the seal properly seated so the door closes tightly and prevents water from leaking out during wash cycles. Replace this retainer if the door gasket keeps slipping out of position or if you notice water leaking around the door.

This is the rinse aid dispenser assembly that mounts inside the dishwasher door and automatically releases rinse aid during the final rinse cycle. It helps prevent water spots and streaking on dishes by reducing surface tension on the water. Replace this part if rinse aid leaks prematurely, the dispenser cap won't stay closed, or your dishes come out spotted despite having rinse aid in the reservoir.

Small mounting clip that secures interior panels and trim pieces in your dishwasher. Replaces clips that are cracked, broken, or missing to restore fit.

Replacement lower dishrack wheel for dishwashers. Installs on the bottom rack to enable smooth rolling. Replace if wheel is cracked, broken, or worn.

This is a small rolling caster wheel designed to support and allow easy movement of the appliance during installation or repositioning. It mounts to the underside of the unit to enable smooth transport across floors. Replace this wheel if it is broken, seized, or missing, which can make the appliance difficult to move and may cause floor damage.

Protective rubber bumper for dishwasher dishrack. Installs on the outer front edge of the lower rack. Replace if cracked, broken, or missing.

Size: 8-32 x 1/4 inch.

Wire harness elbow connector for dishwashers. Replaces damaged, cracked, or broken electrical connectors that route power between components.

This dishrack replaces a damaged, rusted, or warped rack to restore smooth loading and secure support for dishes. A solid rack keeps items upright for better spray coverage, cleaner results, and helps prevent rust transfer and chipping.

• Holds and organizes plates, bowls, and cookware for proper spacing and spray access
• Provides stable support to reduce tipping and breakage during wash cycles
• Replaces racks with rust, broken wires, or bent/missing tines
• Can help resolve issues like rust marks on dishes and loading difficulties

• Disconnect power at the breaker before servicing
• Open the door; slide the old rack out—on some models, release rack stops to remove
• Transfer any reusable accessories from the old rack to the new rack if applicable
• Wear cut-resistant gloves; set the new rack on the rails and verify smooth movement and proper door closure

Touch-up paint for repairing chipped, scratched, or rusted dishwasher racks. Brush-on formula restores appearance where coating is worn or missing.

Screw for wash impeller.

If your dishwasher won't drain completely or leaks water, a damaged pump outlet may be the cause. This part channels water from pump to drain hose.