Kenmore Dishwasher 665.1584990 (6651584990, 665 1584990) Parts

This is a small rolling caster wheel designed to support and allow easy movement of the appliance during installation or repositioning. It mounts to the underside of the unit to enable smooth transport across floors. Replace this wheel if it is broken, seized, or missing, which can make the appliance difficult to move and may cause floor damage.

Secures the cup shelf to your dishwasher's upper rack. Replace this clip if it's broken, cracked, or missing to keep your cup holder stable and secure.

Protective rubber bumper for dishwasher dishrack. Installs on the outer front edge of the lower rack. Replace if cracked, broken, or missing.

Size: 8-32 x 1/4 inch.

Wire harness elbow connector for dishwashers. Replaces damaged, cracked, or broken electrical connectors that route power between components.

Replace your cracked, rusting, or damaged lower dishwasher rack. Restores smooth loading and secure dish placement. Installs in bottom position.

This replacement dishrack restores secure loading and proper spacing so wash water reaches every item. Replacing a bent or rusty rack helps prevent tipped dishes and marks from flaking rust, and keeps loading/unloading smooth when the rack rollers are intact.

• Holds plates, bowls, and cups in place during wash and rinse cycles
• Maintains spacing for spray coverage and drying airflow
• Rolls in and out along the rails when paired with functional rack rollers
• Common symptoms include broken or bent tines, flaking coating or rust, items tipping, or difficulty sliding the rack

• Disconnect power to the dishwasher before servicing
• Open the door, pull the rack forward, release rack stops/end caps if present, and slide the old rack off the rails
• Transfer any reusable accessories from the old rack to the new rack as required by your model
• Slide the new rack onto the rails, reinstall rack stops, and verify smooth travel before running a cycle

Seals the pump housing to prevent water leaking from the tub onto the motor. Replace if you see leaks around the circulation pump area. Confirm fit by model.

Dishwasher spray arm assembly with left and right arms. Installs inside the tub to distribute water during wash cycles. Replace if cracked or broken.

Screw for wash impeller.

Black plastic retainer that secures the dishwasher access panel at the bottom front. Replace if cracked, broken, or missing to properly hold cover in place.

Plastic cap that seals the drain line connection on your dishwasher. Replace if cracked, broken, or missing to prevent leaks and maintain proper drainage.

Protective cap that mounts on the motor shaft to deflect water and prevent moisture from reaching motor windings. Replace if cracked or missing.

Replace your dishwasher's broken or missing silverware basket. This utensil holder sits in the lower rack to organize and clean cutlery during wash cycles.