Samsung Dryer DV363EWBEWR Parts
Genuine Whirlpool part
By: Whirlpool
Part Number: WP35001193
Dryer runs but won't heat? A blown thermal fuse is the most common cause. This overheating safety device protects your dryer's heating system. DIY repair.
Do-It-Yourself Stories from Customers like You
No heat Tony M. • Chester , NJ • February 01, 2015
Removed the heater of course and installed the part. Very easy to do no need to remove the drum, just top cover, control panel, and front door assembly. Remove the one screw holding heater, remove blue wire, turn heater CCW to the 8 o'clock poisiton. Install in the reverse order. This is the secound one in a month if it fails again i'll just bypass it and install a 25 AMP fuse.
Read more
More
$42.95
- Compare At:
-
$51.11
- You Save:
-
$8.16
Genuine Samsung part
By: Samsung
Part Number: 3405-001077
Dryer won't start or stops after a few seconds? The belt switch detects broken belts and prevents operation. Moderate DIY repair, 1-2 hours.
Do-It-Yourself Stories from Customers like You
Ran for 5 to 7 seconds and stopped. Paul K. • Dayton , TX • November 04, 2017
I researched the issue on You tube and found out it could be either the "belt broke switch" or the Moisture sensor. A friend who was an appliance mechanic advised "since you have to take it all apart anyways, its best to replace the belt, spring, and Idler wheel" I bought the 5 item for $52. I watched the video on the AppliancePartsPros for changing out the belt and I replace all items on the list. Took 1 1/2 hrs and was fixed on restart!! * Wear gloves, the sheet metal is very sharp edges!*
Read more
More
$25.35
- Compare At:
-
$29.91
- You Save:
-
$4.56
Genuine Samsung part
By: Samsung
Part Number: DC65-00013A
Dryer not heating? A faulty terminal block connector can prevent power from reaching the heating element. This part secures electrical connections for safe operation.
Do-It-Yourself Stories from Customers like You
Does not blow the dryer heat Eunseok H. • Federal Way , WA • April 30, 2021
Ordered correct parts and received the parts as over night shipping. Then, replaced the heat element and terminal. That's it. Easy. No more this issue for next 10 years.
Purchase of any brand of dryer cost about 600 to 1000. Only I spend around $200 to repair the dryer.
Read more
More
$10.36
- Compare At:
-
$11.40
- You Save:
-
$1.04
Genuine Samsung part
By: Samsung
Part Number: DC97-07618A
Replace your dryer's drum seal gasket when worn or shredded to prevent heat loss and noise. Seals around the drum for efficient drying. Verify fit by model.
Do-It-Yourself Stories from Customers like You
Worn drum seal Steve H. • Salem , OR • October 27, 2015
Replaced w/new seal, easy.
More important was the service I received from you. I first called Samsung, their solution for a worn drum seal was to buy a new S.S. drum for near $300. Your solution was to buy a new seal for under $17, which was in stock and even delivered by Fedex on saturday. The lady I ordered the seal from was efficient and personable, like talking w/an old friend. It was an enjoyable experience, especially the price difference. Next time I need repair parts, you will be...
Read more
More
$123.95
- Compare At:
-
$148.74
- You Save:
-
$24.79
Genuine Samsung part
By: Samsung
Part Number: 6002-000213
The Refrigerator Screw-Tapping is an essential component for maintaining your Samsung refrigerator's functionality. This genuine OEM part ensures precise threading, allowing screws to be securely fastened without damaging the surrounding materials. Designed specifically for Samsung refrigerators, it guarantees a perfect fit and reliable performance. Whether you are replacing a damaged screw-tapping or performing a repair, this Refrigerator Screw-Tapping simplifies the process, saving you time and effort. Its high-quality construction provides durability and long-lasting support for your appliance. By choosing the Refrigerator Screw-Tapping , you ensure your refrigerator remains sturdy and functional, enhancing its overall lifespan. This genuine OEM part is easy to install and seamlessly integrates with your existing setup, making it an ideal choice for DIY repairs. Trust in the quality and compatibility of this Samsung part to keep your refrigerator operating smoothly and efficiently.
Do-It-Yourself Stories from Customers like You
Dryer would not start. John K. • Lawrenceville , GA • November 03, 2017
The start button had been tricky to use. You had to push it in just a certain way to get the dryer to start. Eventually it was non-responsive. All other controls worked and there was no error code displayed. The repair was to replace the whole control board which cost around $100. Heavy sigh..
Be sure to keep track of all your screws.
BTW it was not the thermal fuse. All the online videos say this is the first thing to look for when the dryer will not start. Be sure to check with the person...
Read more
More
$6.41
- Compare At:
-
$7.56
- You Save:
-
$1.15
Genuine Samsung part
By: Samsung
Part Number: DC61-03128A
Replacement leveling leg for dryers. Installs on the bottom corner to stabilize and level your unit. Needed when legs are missing, damaged, or broken.
Do-It-Yourself Stories from Customers like You
When the delivery people set up our washer and dryer we had them stack them when they stacked the dryer on top they removed the feet to put on the new attachment Mike R. • Junction City , KS • August 20, 2021
I found your site online and you had the feet that were missing. I ordered them at 4:00 pm CST and the package was on my porch the next morning by 10:00 am. What great service.
Read more
More
$19.95
- Compare At:
-
$23.94
- You Save:
-
$3.99
Genuine Samsung part
By: Samsung
Part Number: DC97-07510B
Dryer won't start or door won't stay closed? A faulty door catch prevents the door switch from engaging. DIY-friendly fix with video guide.
Do-It-Yourself Stories from Customers like You
I accidentally stepped on the door of my Samsung dryer. The door is intact but brackets bent. Margaret C. • Tampa , FL • June 07, 2018
I am so blessed. I went online. Found the brackets. Watch the video for the brackets I chose. And lucky me. I did not have to pull the dishwasher out. The installer did not have it flush under the counter. So I was able to pull the dishwasher forward unhook the damage brackets and insert the new. Put the dishwasher back in. Two screws. Now the balanced and secure dishwasher washes better than ever and I did not have to pay an extraordinary fee for a repairman. I'm 68 and take care of a 72 year...
Read more
More
$28.95
- Compare At:
-
$34.16
- You Save:
-
$5.21
Genuine Whirlpool part
By: Whirlpool
Part Number: W11233072
This factory screw secures appliance components to their mounting points. Replace missing, worn, or stripped hardware to restore a tight fit, proper alignment, and quieter operation across the affected assembly.
- Fastens panels, brackets, covers, or internal parts to the chassis or frame
- Helps maintain alignment and support, reducing rattle, vibration, or looseness
- Replaces missing or damaged screws that have backed out, broken, or stripped
- Restores secure mounting after service when original hardware is lost
What's included: 1 screw Install notes:
- Disconnect power; shut off water or gas supplies before servicing
- Use the correct driver; start threads by hand to avoid cross-threading
- Match length and thread to the original location; do not substitute with longer hardware
- Tighten snugly; do not overtighten into plastic or thin metal
Do-It-Yourself Stories from Customers like You
Bake element broken on jenn air model s125 downdraft slide in range Patricia D. • Raleigh , NC • May 02, 2015
Ordered Bake Element, Y04100019 (Whirlpool AP4283614) to replace a broken bake element on my 30-year old Jenn-Air Model S125 Downdraft Slide-in electric range. Received the element very quickly but it had been damaged in shipping. Called AppliancePartsPros to report this and they quickly shipped another element - very easy process.
To install the element, I turned off the power to the range, put on rubber gloves (just in case) and removed the two sheet metal crews at the rear of the oven -...
Read more
More
$21.46
- Compare At:
-
$25.54
- You Save:
-
$4.08
Genuine Samsung part
By: Samsung
Part Number: 6021-001201
Secures dryer components firmly in place. Replace if nut is stripped, missing, or no longer holds tight. Essential hardware for proper installation.
More
$12.14
- Compare At:
-
$13.35
- You Save:
-
$1.21
Genuine Samsung part
By: Samsung
Part Number: DC66-00395A
Dryer door won't close or latch properly? This door latch lever assembly fixes broken door catches. Straightforward repair with video guide.
Do-It-Yourself Stories from Customers like You
I accidentally stepped on the door of my Samsung dryer. The door is intact but brackets bent. Margaret C. • Tampa , FL • June 07, 2018
I am so blessed. I went online. Found the brackets. Watch the video for the brackets I chose. And lucky me. I did not have to pull the dishwasher out. The installer did not have it flush under the counter. So I was able to pull the dishwasher forward unhook the damage brackets and insert the new. Put the dishwasher back in. Two screws. Now the balanced and secure dishwasher washes better than ever and I did not have to pay an extraordinary fee for a repairman. I'm 68 and take care of a 72 year...
Read more
More
$13.95
- Compare At:
-
$16.60
- You Save:
-
$2.65
Genuine Samsung part
By: Samsung
Part Number: DC96-00766A
The Dryer Touch Wire Harness Assembly ensures seamless connectivity within your Samsung dryer. This essential component facilitates the operation of your dryer's touch controls, providing reliable performance and responsiveness. Crafted as a genuine OEM part, it guarantees compatibility and a perfect fit for various Samsung dryer models. Installing the Dryer Touch Wire Harness Assembly restores the functionality of your dryer's control panel, enhancing your appliance's efficiency and ease of use. Whether your current harness is frayed, damaged, or malfunctioning, this genuine OEM part offers a durable and dependable solution. By choosing the Dryer Touch Wire Harness Assembly, you ensure the high performance and longevity of your Samsung dryer, providing a smooth and user-friendly drying experience. Trust in this quality part to keep your dryer operating at its best, making your appliance maintenance straightforward and effective.
Do-It-Yourself Stories from Customers like You
Failed Door Switch and missing Lint Filter. Brian M. • Decatur , IL • May 11, 2023
Replace both the lint filter and door switch.
Read more
More
$15.01
- Compare At:
-
$17.64
- You Save:
-
$2.63
Genuine Samsung part
By: Samsung
Part Number: DC61-00891A
Supports your dryer door and allows smooth opening and closing. Replace if the door sags, has excessive play, won't stay shut, or the hinge is cracked.
Do-It-Yourself Stories from Customers like You
Front loader door would not stay shut Kenneth K. • Victoria , TX • November 16, 2018
I fixed it by replacing the door switch assembly, door hinge and hinge bushing. The videos you provide was a great help on fixing the problem in no time at all. Ordered parts arrived the next day plus the parts were the correct ones.
Read more
More
$4.31
- Compare At:
-
$4.74
- You Save:
-
$0.43
Genuine Samsung part
By: Samsung
Part Number: 6001-001773
Dryer Mounting Screw is essential for securing your Samsung dryer firmly in place, ensuring it operates safely and efficiently. This genuine OEM part guarantees a perfect fit, providing the necessary stability and support for your appliance during its operation. Crafted from high-quality, durable materials, the mounting screw offers long-lasting performance and reliability, standing up to the demands of daily use. Installing the Dryer Mounting Screw is straightforward, enabling you to restore your dryer's functionality quickly and without hassle. By replacing worn, missing, or damaged screws with this genuine OEM part, you maintain the structural integrity and proper alignment of your Samsung dryer, which is crucial for optimal performance. This Dryer Mounting Screw helps prevent excessive vibration and potential damage to your appliance, thereby enhancing its overall efficiency and lifespan. Compatible with a wide range of Samsung dryer models, it ensures a secure fit and dependable operation every time. Trust in this genuine OEM part to deliver exceptional quality and support the optimal performance of your dryer, ensuring it operates smoothly and efficiently for years to come. Whether you're performing routine maintenance or undertaking a repair, the Dryer Mounting Screw is a reliable choice for keeping your Samsung dryer in top condition.
More
$6.41
- Compare At:
-
$7.63
- You Save:
-
$1.22
Genuine Samsung part
By: Samsung
Part Number: DC61-03202A
Replacement door hinge for dryers. Installs on the door assembly to allow smooth opening and closing. Needed when original hinge is broken or cracked.
Do-It-Yourself Stories from Customers like You
Front loader door would not stay shut Kenneth K. • Victoria , TX • November 16, 2018
I fixed it by replacing the door switch assembly, door hinge and hinge bushing. The videos you provide was a great help on fixing the problem in no time at all. Ordered parts arrived the next day plus the parts were the correct ones.
Read more
More
$35.20
- Compare At:
-
$37.14
- You Save:
-
$1.94
Genuine Samsung part
By: Samsung
Part Number: DC97-07895A
Connects your dryer's ductwork to the exhaust system for proper airflow. Replace if cracked, broken, or causing poor drying. Confirm fit with your model.
Do-It-Yourself Stories from Customers like You
My blower wheel and assy duct connector was broken Linda P. • Woodstock , MD • August 04, 2015
I watched your video and it was very easy. The video made it so simple and step by step instructions made it easy to follow. I even called and spoken to someone there and he was very helpful. thanks so much my dryer is running again.
Read more
More
$52.95
- Compare At:
-
$62.48
- You Save:
-
$9.53
Genuine Samsung part
By: Samsung
Part Number: DC97-12150A
Replace broken, missing, or worn dryer leveling legs. Includes bracket and adjustable leg to stabilize and balance your dryer for proper installation.
Do-It-Yourself Stories from Customers like You
Removed washer and dryer from pedestal and found replacement legs were not left with the pair when installed Laura C. • West Dundee , IL • February 18, 2015
Ordered legs through ApplianceParts Pros
Read more
More
$29.31
- Compare At:
-
$34.88
- You Save:
-
$5.57