Samsung Washer WF419AAWXAA Parts
Genuine Samsung part
By: Samsung
Part Number: DC61-01257L
Supports the drum and absorbs vibrations to reduce noise and prevent walking during spin cycles. Replace if washer is unbalanced or excessively noisy.
Do-It-Yourself Stories from Customers like You
Washer would walk all over the room during spin cycle William E. • Flowery Branch , GA • December 06, 2019
Only run 2 loads through after the repair, but I fixed it by replacing all suspension components. I replaced the 2 front shocks, the 2 rear shocks (different part number), and the 2 springs. I followed the repair video and it was close enough for the whole job to be done in an hour. The hardest part was getting the door spring out from around the gasket.
Read more
More
$53.95
- Compare At:
-
$64.20
- You Save:
-
$10.25
Genuine Samsung part
By: Samsung
Part Number: 6009-001522
Replacement hex screw for dryers. Fastens internal components securely in place. Order when original screws are stripped, missing, or lost during repair.
More
$14.14
- Compare At:
-
$15.55
- You Save:
-
$1.41
Genuine Samsung part
By: Samsung
Part Number: DC62-00183A
Fix water leaks from your washer's spray nozzle assembly with this connector. Common cause of floor puddles and damp connections. Easy DIY repair.
Do-It-Yourself Stories from Customers like You
The problem began with the "temperature sensor problem" error Khac T. • Westford , MA • February 12, 2015
When I opened the rear cover and check the temperature sensor, I noticed the wire connection was damp. I dried it up with a hair dryer and it worked again for a few days. Then the problem came back.
When I gone back to inspect the second time, i noticed a lot of water on the floor. I knew there was a leak. I followed the disassemble samsung washer video from "Repair clinic.com" to open the top cover, then i realized the assembly hose was busted.
I ordered the parts from this site and...
Read more
More
$2.52
- Compare At:
-
$3.00
- You Save:
-
$0.48
Genuine Samsung part
By: Samsung
Part Number: DC67-00089A
Replacement water supply hose for washers. Connects water inlet to the washer. Replace if cracked, leaking, worn, or damaged for proper water flow.
Do-It-Yourself Stories from Customers like You
I was changing the washer door seal and the water supply hose broken when disconnecting Ruben M. • Wahiawa , HI • August 15, 2026
I scoured the Internet for the part and only Appliance Part Pros had it
Read more
More
$21.25
- Compare At:
-
$25.29
- You Save:
-
$4.04
Genuine Samsung part
By: Samsung
Part Number: DC67-00444A
The Washer Max Fill Cap is designed to regulate the maximum water level in your Samsung washer. This genuine OEM part ensures that your appliance fills with the optimal amount of water for each wash cycle, enhancing cleaning efficiency and conserving water. By maintaining the correct fill level, the Max Fill Cap helps prevent overfilling, which can lead to leaks or excessive water usage. If your original fill cap is damaged or worn, replacing it with this genuine OEM part restores your washer's performance and reliability. Installation is straightforward, allowing you to quickly restore your washer's functionality without hassle. The Washer Max Fill Cap is compatible with a range of Samsung washer models, providing a reliable solution for maintaining your appliance's efficiency. Using this genuine OEM part ensures that your washer continues to operate smoothly, meeting Samsung's high-quality standards. Trust in the Washer Max Fill Cap to deliver lasting durability and consistent performance, keeping your laundry routine running seamlessly.
Do-It-Yourself Stories from Customers like You
Detergent cup full of water at end of cycle Daniel M. • Tinley Park , IL • May 06, 2016
Replaced with new Detergent cup and fill cap. Cup symphony perfectly. Simple fix for frustrating problem.
Read more
More
$8.76
- Compare At:
-
$10.42
- You Save:
-
$1.66
Genuine Samsung part
By: Samsung
Part Number: DC61-10673A
If water pools under your washer or drains slowly, a damaged drain cap may be the cause. This cap prevents leaks and controls water flow during cycles.
Do-It-Yourself Stories from Customers like You
He unit would shake like it was off balance Bernard M. • Lebanon , OR • November 24, 2015
At first I thought it was the bearing, but when I got it apart I found the main shaft had corroded from possibly the soap powder and bleach combo build up on the part.
After I cleaned it all up I found one of the three mounting braces was cracked and causing the unit to shake during the spin cycle.
Once I replaced that part and replaced a few missing parts I lost all found on your store the unit went together just as it came apart and works excellent.
Read more
More
$5.50
- Compare At:
-
$6.49
- You Save:
-
$0.99
Genuine Samsung part
By: Samsung
Part Number: 6002-000520
Self-tapping screw for appliance assembly and repairs. Secures handles, bins, shelves, and components. Replace missing or stripped screws during moves or repairs.
Do-It-Yourself Stories from Customers like You
Pieces to the oven handle broke Kathy M. • Lacey , WA • December 24, 2015
Went online to repairclinic.com and it was a simple as typing in the serial # to find the correct parts. Shipping was very quick and the handle was completely repaired within days.
Read more
More
$6.41
- Compare At:
-
$7.69
- You Save:
-
$1.28
Genuine Samsung part
By: Samsung
Part Number: DC97-12578C
Replaces a cracked, burst, or leaking hose assembly in your washer. Installs under the top panel between the dispenser and water inlet valve.
Do-It-Yourself Stories from Customers like You
The problem began with the "temperature sensor problem" error Khac T. • Westford , MA • February 12, 2015
When I opened the rear cover and check the temperature sensor, I noticed the wire connection was damp. I dried it up with a hair dryer and it worked again for a few days. Then the problem came back.
When I gone back to inspect the second time, i noticed a lot of water on the floor. I knew there was a leak. I followed the disassemble samsung washer video from "Repair clinic.com" to open the top cover, then i realized the assembly hose was busted.
I ordered the parts from this site and...
Read more
More
$61.56
- Compare At:
-
$73.26
- You Save:
-
$11.70
Genuine Samsung part
By: Samsung
Part Number: DC61-02166A
This is the pump housing or pump case that encloses the drain pump assembly on a front-load or top-load washing machine. It directs water flow through the drain pump and includes the filter access cover. Replace this part if you notice water leaking from the pump area, the drain filter is cracked or won't seat properly, or the pump housing is visibly damaged.
Do-It-Yourself Stories from Customers like You
Pump making loud noise off and on Donny W. • Redding , CA • October 22, 2014
Removed and replaced the pump and housing. Buy the housing too because when you remove the screws the plastics threads come out too.
Read more
More
$45.50
- Compare At:
-
$54.14
- You Save:
-
$8.64
Genuine Samsung part
By: Samsung
Part Number: DC97-14278A
Fix washer water leaks with this drain pump filter assembly. Traps debris and lint to prevent blockages and ensure smooth water flow during cycles.
Do-It-Yourself Stories from Customers like You
Water leak. Len D. • Jurupa Valley , CA • July 06, 2020
Part fit perfectly, great next day delivery.
Read more
More
$26.95
- Compare At:
-
$32.34
- You Save:
-
$5.39
Genuine Samsung part
By: Samsung
Part Number: DC61-02432A
Stabilizes your washer drum during spin cycles. Replace if damaged or causing excessive vibration. Confirm fit with your model number before ordering.
Do-It-Yourself Stories from Customers like You
Samsung washer wf431abp/xaa 001 had vibration issues Harold H. • Kimberling City , MO • January 29, 2019
Appliance Parts Pro had a great video showing what the most likely problem was and how to fix it. Using the video, I disassembled the washer and removed the suspect part (Spider Arm), which I found to be cracked. I order the needed parts on a Thursday afternoon and had the parts in hand on Saturday afternoon. Reassembly was straightforward and the washer now works like new. The most difficult part is the manhandling of the drum out and back into the washer. It is heavy and awkward for one...
Read more
More
$5.95
- Compare At:
-
$7.02
- You Save:
-
$1.07
Genuine Samsung part
By: Samsung
Part Number: 6001-001668
Machine screw for Samsung washers and dryers. Secures internal components and panels. Replace if screw is stripped, missing, or damaged during repairs.
More
$6.41
- Compare At:
-
$7.63
- You Save:
-
$1.22
Genuine Samsung part
By: Samsung
Part Number: 6001-001773
Dryer Mounting Screw is essential for securing your Samsung dryer firmly in place, ensuring it operates safely and efficiently. This genuine OEM part guarantees a perfect fit, providing the necessary stability and support for your appliance during its operation. Crafted from high-quality, durable materials, the mounting screw offers long-lasting performance and reliability, standing up to the demands of daily use. Installing the Dryer Mounting Screw is straightforward, enabling you to restore your dryer's functionality quickly and without hassle. By replacing worn, missing, or damaged screws with this genuine OEM part, you maintain the structural integrity and proper alignment of your Samsung dryer, which is crucial for optimal performance. This Dryer Mounting Screw helps prevent excessive vibration and potential damage to your appliance, thereby enhancing its overall efficiency and lifespan. Compatible with a wide range of Samsung dryer models, it ensures a secure fit and dependable operation every time. Trust in this genuine OEM part to deliver exceptional quality and support the optimal performance of your dryer, ensuring it operates smoothly and efficiently for years to come. Whether you're performing routine maintenance or undertaking a repair, the Dryer Mounting Screw is a reliable choice for keeping your Samsung dryer in top condition.
More
$6.41
- Compare At:
-
$7.63
- You Save:
-
$1.22
Genuine Samsung part
By: Samsung
Part Number: DC96-00757A
Replacement power cord for washers. Connects washer to wall outlet for electrical supply. Replace if cord is damaged, frayed, chewed, or cracked.
Do-It-Yourself Stories from Customers like You
Samsung front load washer not powering on. Dustin B. • Orange , TX • June 03, 2019
First I checked the breaker and outlet and both were good...then I unplugged the machine, took the top off, and removed the control panel. I check the wiring to see if there were any loose plug ins, etc...This is where I figured the panel was bad (or possibly the power cord) so I ordered both. The parts arrived the next day. (incredibly fast shipping) Since I wasn't expecting them til after the weekend I left everything disassembled and went on a mini vacation for a couple of days. Upon...
Read more
More
$92.95
- Compare At:
-
$110.61
- You Save:
-
$17.66
Genuine Samsung part
By: Samsung
Part Number: DC31-00097B
Fix a washer that won't spin or shows a 3E error code with this brushless motor assembly. Common repair for slow spinning or humming without rotation.
Do-It-Yourself Stories from Customers like You
3E error code William T. • Nashville , TN • May 18, 2021
I watched the Appliance Parts Pros video on YouTube. It showed me how to access and check the suspected parts. I inspected the parts and found arcing on the connection between the stator and position sensor. I ordered the parts at Appliance Parts Pros. When they arrived, I installed and checked out the washer. It was good to go. Thanks for the informative video and easy ordering experience!
Read more
More
$255.95
- Compare At:
-
$302.02
- You Save:
-
$46.07
Genuine Samsung part
By: Samsung
Part Number: DC65-00014A
The Washer Hose Clamp is designed to securely fasten hoses on your Samsung washer, ensuring a leak-proof connection. This genuine OEM part guarantees a perfect fit and reliable performance for your appliance. Crafted from durable materials, the clamp withstands the rigors of daily washing cycles, providing long-lasting support and stability. Installing the Washer Hose Clamp is straightforward, allowing you to quickly restore your washer's functionality without hassle. This part is specifically compatible with a range of Samsung washer models, ensuring seamless integration and optimal performance. By choosing this genuine OEM part, you maintain the efficiency and safety of your washer, preventing potential leaks and hose disconnections. Whether youGÇÖre replacing a broken or worn clamp, the Washer Hose Clamp offers a dependable solution to keep your washer running smoothly, enhancing your overall laundry experience with reliable and consistent results.
Do-It-Yourself Stories from Customers like You
Noisy jumping around while spinning David H. • Vestavia , AL • February 16, 2025
Replaced drum bearings. Replaced front shocks, one had hardly any resistance. Replace both door boot clamps. Always take pictures as you take apart ! Learned the hard way years ago !
Read more
More
$8.26
- Compare At:
-
$9.38
- You Save:
-
$1.12