Poulan Spring Parts

This genuine Husqvarna idler spring on a snowblower is attached to the idler arm and to a bracket that holds it in place. The function of an idler spring on a snowblower is to secure tension on its drive belt.The idler spring of a snowblower might have to be replaced if there is damage that loosens the tension of the spring and prevents the spring from holding components in place. Damage to the idler spring can manifest from long-term use, overexposure, or a collision with a hard object. If the idler spring is subject to damage that results in the loosening tension of the idler arm, the idler spring should be immediately removed and replaced, and the snowblower should not be used again until a new idler spring has been installed. Remember to always wear gloves when handling, repairing, and operating outdoor equipment. This idler spring is compatible with the following brands: Husqvarna and Poulan. This part is sold individually.

This replacement driver spring is a genuine OEM part for a string trimmer with a starter rope ignition. When an operator pulls the starter rope, the rope must recoil back into the starter assembly before it can be used again. This spring connects to a driver pulley in the starter assembly and maintains the right amount of tension needed to recoil the pulley. Over time, driver springs will begin to lose some of their tension. This is especially true if the operator is quite rough on their appliance. Pulling too hard on the starter rope can wear out the spring more quickly, making it less effective. Without a properly tensed driver spring, the starter rope will not recoil into the assembly. To change out the spring, use a nut driver to open the starter assembly and remove the pulley to get access to the old spring. Carefully remove it and install the new part. This replacement driver spring is a high-quality part designed to match the exact specifications for a Husqvarna or Jonsered appliance. This part is sourced from its original manufacturer and ships individually.

This genuine OEM hub spring is designed to fit select models of chainsaws. The hub spring is responsible for providing the spring action that reacts to the pull starter. This generates the power that rotates the flywheel and helps engage the engine in the starting process. The spring becomes worn and extended with regular use. Since it is metal, it may also be subject to corrosion or other environmental damages. In either case, the hub spring should always be replaced promptly if it is found to be defective or damaged in any way. This genuine hub spring can be used for a variety of chainsaws from Poulan, Husqvarna, AYP, Sears/Craftsman, Roper, Poulan Pro, and Weed Eater. This item is sold as an individual unit. Springs are under pressure and can be dangerous to replace so always use caution. Allow the engine to cool before beginning repairs and always wear gloves for any kind of engine part repairs or replacements.