1 Answer Bill, Unfortunately this door hinge 00487747 has been discontinued by the manufacturer with no suitable replacement available. Read More...
Tom M December 27, 2014 for Model Number SMW272YS Serial # 37 2 07 0081310 00042 I am looking for the part number for the hinges. The door is 27 inches and it is stainless.
Steve November 16, 2014 for Model Number smw272 Need to order the correct door hinges. Please advise.
1 Answer Steve, for the 27" door use part number 00487747 and for the 30" door use part number 00487746. Thanks! Read More...
Jamie S. March 23, 2014 for Model Number thermador model SCD302TP Need the correct hinge for my unit can you help me? Thanks.
Alex February 01, 2014 for Model Number SEMW272 I am looking for oven door hinges (Thermador, Bosch oven/microwave/warmer st model# SEMW272. Thanks!
John April 22, 2013 for Model Number Thermador oven model no scd272tp Need to replace door hinges not sure witch one fits, (1 or 29)?
1 Answer John, if you have a black or white door you will use part number 00487747 and if you have a stainless door you will use part number 00487746. Thanks! Read More...
Cindy A. April 12, 2013 for Model Number SC272TS I have model# SC272TS and I need new door springs. I just want to double check that I need part number AP2837518. Thanks, Cindy
1 Answer Cindy, the door hinge 00487747 is the correct replacement for your 27" model SC272TS. Thanks! Read More...
Tim December 28, 2012 for Model Number SC272ZS Seems there are two hinges for the Thermador SC272: 414511 and 487747. 414511 is more expensive, and I seem to have seen an indication that this is a newer more robust model. Is this correct?
1 Answer Hello Tim, For a 30" door use part number 00487746 and for a 27" door use part number 00487747. The model number you listed will take the 00487747. Read More...
Dan October 14, 2012 I have a thermador SMW272YP oven. Two problems. One is that when I previously was cleaning the oven, the thermal switch popped out. I reset and since then I sometimes get F2 or F4 error even at temperatures below 450 degrees. I am currently trying to cause failure to be sure of code, but now it is working (even cleaning currently). Should I replace this? Second, my lower oven door does not close. I see this is a common problem. Are there replacement parts which will alleviate this problem for good or what are the best set of parts to buy and replace for this situation?
1 Answer Hi. F2 = Over temperature detected. Intermittent temperature sensor or bad main relay board part # 00702450 (single oven).Double oven is part # 00702451. Replace the temperature sensor. If control still displays F2, replace main relay board. F4 = Shorted sensor. A short circuit in the oven wiring. Check all connections. check resistance of the sensor part # 00414152 for 1050 ohms @ 77°. The door hinge is part # 00487747. Hinge receiver part 3 00414510. They both require replacing at the same time for a proper door operation. Thank You. Read More...
Bryan March 02, 2012 for Model Number Thermador double oven C302CS s/n 81030184 Weak door springs doesn't close completely and need to know what to order. Where do I measure to determine which to order or does the "30" in the model number designate 30". Also how do you remove it?