Skip to Content
  • Same-Day Shipping Same-Day Shipping
  • 365 Day Return Policy! 365 Day Return Policy!
  • Trusted Since 1999 Trusted Since 1999
  • 5,000+ Repair Videos 5,000+ Repair Videos
  • Repair ForumFree Tech Support!
  • Top Quality Store on Google

Customer Questions and Answers for Washer Drain Pump by Bosch

Best Seller
Manufacturer Part
4.89 (64)
By: Bosch
Part Number: OEM12928830
Manufacturer Part Number: 00144486

Fix a washer that won't drain or hums during drain cycle. This drain pump removes water during wash cycles. DIY repair takes 20-90 minutes.

More
$129.95

IN STOCK
Ships Monday Guaranteed
Add to Cart

Questions & Answers

For Bosch Washer Drain Pump (Part Number: OEM12928830)

Sande for Model Number SHU9956UC/14

The pump continues to run trying to drain water out after there is no water left. Happened at the end of a rinse cycle, and at the end of a test wash cycle. Time still shows 1 minute left and the cycle won't move on to rinse. Pump just seems to be trying to drain. The furnace had turned off in January and the house got down below freezing before a "house sitter" found out. This might have some bearing on the dishwasher situation. Would a new pump, or new control panel, be in order? Or a total replacement?

1 Answer

Sande, based on the information provided, it sounds like there is water in the base pan located under the dishwasher. It is recommended that this is checked and if there is water, the water be cleared out. Once the water is cleared, a cycle can be started and the pan inspected for the source of the water during the cycle.

Read More...

1 Answer

Eric, Bosch does not provide us with the dimensions on the part you are asking about, parts can be returned as long as they have not been installed.

Read More...

1 Answer

John, The correct drain pump assembly for the model number you supplied is 00436440 / 00436440 Washer Drain Pump. The part is in stock and available at this time. To replace the drain pump, Remove front panel, loosen and remove hoses. Disconnect wire harness and carefully slide pump toward rear of washer, then lift it out of washer (taking care to not damage the four rubber feet). Drain pumps are mounted on four rubber feet to dampen vibration & noise. To remove drain pumps, carefully slide them toward rear of washers. To install them, carefully insert all four feet into notches in washer base, then slide them forward. Reverse the procedures and test the machine for operation and drain. Thanks,

Read More...

1 Answer

Hello Brandon,
If the model number is WFMC1001UC/01, you will need to order 00436440. If the model is different you may want to verify the model number from the units' I.D. tag before ordering this part since there are multiple model numbers within the "Nexxt 100 Series" classification.

Read More...

Have questions? Ask our pros!

Contact us in a way that is convenient for you

Call us 1-877-477-7278
Need Help? Chat with a Pro
Or ask a question by filling in the form

Share your thoughts with other customers

Ask a Question
  • 5,000+ Repair Videos 5,000+ Repair Videos
  • Same-Day Shipping Same-Day Shipping
  • 365 Day Return Policy! 365 Day Return Policy!
  • Repair ForumFree Tech Support!
  • Top Quality Store on Google