Jim July 14, 2017 for Model Number FGID2474QF4B No lites on control panel. suspect control board. where is it located on dishwasher.
1 Answer Jim, The control board for this unit will be located behind the kickplate of the unit. This issue sounds like it may be a faulty control panel but check connections at the control board. Read More...
Rodger March 31, 2017 for Model Number FQID2474QFOAFr I have a brand new Frigidaire Galley should any off the lights be on the light panel when the dishwasher is running.
1 Answer Rodger, We are not showing information on the unit having the lights on other than the clean light at the end of the cycle. Read More...
Ruben January 14, 2017 for Model Number FGID2474QF My dishwasher turn all lights off when door is closed, I can select any program and it works perfect until the end of the cycle, for programing it shows all lights on, and when I do press Start, it display "close door" when I close the door the dash turn off, at the end of the cycle the green led is on. So appear to work properly, it is normal that works that way? Thanks.
1 Answer Ruben, This issue sounds like it would be a control board that is faulty. The lights should stay on when the unit is operating. Read More...
Agatha November 24, 2016 I have a frigidaire dishwasher and the sanitize light is red. It also does not dry the dishes well. Wash cycle is fine. Please help, why is the sanitize light red and not drying well?
1 Answer Hello Agatha. We will need your model number to help you with this. Please call 1-877-477-7278 or post your model number with a new question on the parts page. http://www.appliancepartspros.com/modelnumber_locator.aspx Read More...
M White October 15, 2016 for Model Number Frigidaire Dishwasher Model FDB2310LCC2 My washer goes thru all the cycles, we can here it fill with water, we can hear it drain and the heating elements work, however when we open it up it seems no water has been sprayed anywhere. I bought a new impeller motor reinstalled and ran the washer again and I have the same problem, seems like no power goes to the impeller motor during the wash cycles. Could this be the control board?
1 Answer M. White, If there is no power going to the motor then this would be a control board issue in which the control board will need to be replaced. Read More...
Tom October 14, 2016 for Model Number LGID 2475QFOA I have a Frigidaire dishwasher 3 years old it runs constantly even with door open. I shut off the breaker for over an hour when i turned it back on it continued to run
1 Answer Tom, BAsed on your information and description the problem would be in the Control assembly 5304533996 / 117492610 located behind the kick plate and lower access panel. There's a shorted circuit on the board causing the control board to remain energized all the time. Read More...
Lloyd August 16, 2016 for Model Number FGHD2465NF1A I set the washer for a quick wash, and after running for a while, it switches to normal. Also once it's finished, an error illuminates (Washing Drying ER S Clean). When shut, you can hear it trying to run on its own, but nothing is happening. I replaced the control board a few months ago. Please help. Thanks
1 Answer Hello Lloyd. If the control board is new, you will need to order and replace the console assembly 807545704 on the unit. Read More...
Dianne August 04, 2016 for Model Number FFBD2406NW0A I have a 3 year old Frigidaire dishwasher. I went to turn it on and it started Now the normal wash light is on but it is not running. Nothing happens when I press any thing else. The light does not go off when I open the dishwasher door. I do hear the door latch click when I shut it. Any suggestions?
1 Answer Hello Dianne. Test and make sure the door switch is good in the unit. You will need to test for power to the motor. If there is power there, and the motor does not run, replace the motor. If there is no power there, then you will need to replace the board. You can test this with a multi-meter TJMA-DMT3. Here is a link on how to use a multi-meter. http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html Read More...
Teresa July 23, 2016 I have a Frigidaire Dishwasher. My rinse only light is on and I can't get it off. I can't use my dishwasher. What do I need to do
1 Answer Hello Teresa. We will need your model number to help you with this. Please call 1-877-477-7278 or post your model number with a new question on the parts page. http://www.appliancepartspros.com/modelnumber_locator.aspx Read More...
Chuck June 14, 2016 for Model Number FGID2474QF4B Got up this morning and the dishwasher was humming. Should have finished running the previous evening. Opened the door and the unit continues to hum. Buttons do not respond and the one that is displayed says .30. Turned off the breaker, waited awhile and then cut it back on. Nothing changed. Any ideas? thanks,
1 Answer Hello Chuck. It sounds like the control board 5304533996 is bad and will need to be replaced on the unit. Read More...