Susan October 04, 2017 for Model Number GLRS267ZA When using the ice maker, water drips into the fridge. Is this just because I need a new Pure Source 2 filter? It also drips water when the ice maker is making ice. I just ordered a new filter and hoping that will do the trick!
1 Answer Susan, The filter could be an issue and would suggest pulling the filter out and looking for cracks in it. If the filter does not correct then the filter head would be the issue. Read More...
Lori September 17, 2017 for Model Number FRS26H7CSB2 Attempted to change filter. New one pops out when you try to run water through. Old filter stays in. What am I doing wrong?
1 Answer Hello Lori. It sounds like the water filter base 240396002 is bad and will need to be replaced on the unit. Thanks. Read More...
Nicki September 14, 2017 for Model Number FGHB2866PFGA About 6 months ago I purchased an off brand water filter. It worked fine and was easy to install. It was time to replace and it was stuck. It took forever for my husband to get it out. We decided to get the Frigidaire model this time, the PureSource Ultra, and it will not click into place. Any suggestions?
1 Answer Nicki, It is showing the correct filter for this unit will be ULTRAWF and if it is not clicking into place then this will be a faulty filter head 242009604. Read More...
Mary Diaz September 08, 2017 for Model Number I have a 2001 Frigidaire side by side. Mod. FRS23HF5A Icemaker/water filter is Electrolux NGFC2000.. I can't tell if the replacement part no.FC100 is the correct part. It looks the same as the one I have. I haven't found any other parts that resemble it. Is this the one I should purchase. PURE SOURCE2. Thanks
1 Answer Mary, The correct water filter to order for the basic model number you supplied is WF2CB / 240396401 PURESOURCE2™ Water Filter (WF2CB). The part is in stock and available at this time. Thanks, Read More...
Troy August 21, 2017 for Model Number Frs26kf6cb2 Relaced water filter. When dispensing water filter will pop out. Old filter stays in. Chaned twice in one day. With new filter and both pop out. What would cause this problem.
1 Answer Hello Troy. You will need to order 240396002 for the filter base needed for the unit. This should repair the issue. Read More...
Christina July 20, 2017 Using wf2cb, the filter light is still red when it was just replaced. Help please.
1 Answer Hello Christina. You will need to reset the filter light after replacing the filter in the unit. Read More...
Kristen July 19, 2017 for Model Number 253.44303400 I just replaced my Frigidaire filter with the WF2CB PureSource2 Ice And Water Filtration System without any hassles, but it sounds like my refrigerator is working harder now. I believe the noise I am hearing is a fan, and it's consistently working. Any ideas?
1 Answer Hello Kristen, This does not sound like a problem that would relate to the water filter. I would check the evaporator fan motor by stopping it and see if it starts back to full speed without assistance. If not, the fan motor 809069220 is definitely experiencing a problem. Read More...
Jenna July 05, 2017 for Model Number FFHS2322MSFA I just tried to replace water filter on my fridge with filter WF3CB which is correct filter. It fits in and stays but when I try and dispense water it i leaking out from all over. Please help
1 Answer Jenna, With the filter being good it sounds like the filter head may be what is leaking and would need to be replaced. Read More...
Sandra C June 04, 2017 for Model Number Fridgedaire FFHS2313LS8 side by side refrigerator The water is no longer dispensing so tried to pull the filter (only 3 months in use and have changed it many times) but cannot push it in to get the usual click so it can be pulled out. Really stuck in there.. Never had this problem before. Is this an issue with the casing or something else?
1 Answer Sandra, This issue would most likely be caused by a faulty filter head assembly. Read More...