Cheryl February 06, 2014 for Model Number G1WN3000 I believe that part numbers I need are AP5607528 and AP3702594 the drum in my washer leans to the left and clunks/grinds when in the spin cycle it had a problem for a while when spinning it did not seem level and jumped until I rearranged the clothes the last load I did is when the drum started to lean. The machine works well until it gets into the middle of the spin cycle and then starts to make grinding noises. How difficult is it to install these parts and how do I take the front panel of the washer off to see if I can see the broken spring/springs Thank you
1 Answer Hello Cheryl. The model number you provided is not working. We will need your correct model number to answer these questions for you. Please call 1-877-477-7278 or post your model number with a new question on the parts page. http://www.appliancepartspros.com/modelnumber_locator.aspx Read More...
Doug July 30, 2013 for Model Number WJRE5500G0WW My GE washer belt keeps popping off. It is tight and not stretched, but it looks like the motor pulley and the tub pulley don't line up . This causes the belt to ride off.Whats the reason, whats the fix? Any help would be appreciated
1 Answer Hello Doug. Check and see if the pulley nut is loose. If not, you need to replace the Mode shifter WH38X10017. Read More...
Bob June 30, 2013 for Model Number GE GSD2200G02BB I am looking for the plastic extender that is attached to the door spring.
1 Answer Bob, The plastic part that the door spring attaches to is the hinge arm link WD14X10009. Read More...
Danmariana@Aol.Com December 08, 2012 for Model Number wpre6100g2wt The motor touches the bottom frame making noise.If i have to replace the rod springs is any trick to do it or i can watch a video somewhere?
1 Answer Hello Danmariana@aol.com, There is no special tricks for changing the rod springs. You may want to have an extra pair of hands to help support and lift tub. Read More...
Lionking August 31, 2011 for Model Number WPRE6100GOwt Where is the plastic socket that this support arm fits into? Mine's broken, and I need a new one for the front support Arm.
1 Answer Hello Lionking. WH01X10001 is the part number for the support rod socket. Hope this helps. Read More...
Lu June 01, 2011 for Model Number WPRE8100GOWT On my 2005 GE Profile washer, this part is on the front and the green ones are on the rear, instead. Is that why it makes a lot of noise when spinning (seems out of control ) and at the end the clothes are still wet? Thanks!
1 Answer Hello Lu. It sounds like the rod/springs are bad and will need to be replaced. You will want to install the new ones on the washer the same way you take the old ones off. Also check and make sure the pump WH23X10030 is not clogged. Hope this helps. Read More...