Dan May 03, 2012 for Model Number wm2277hb I have the lg wm2277hb.When I start a wash cycle the drum jerks one way then the other.After some time the LE code comes on.I have turned the drum by hand and it turns freely.The washer eventually turn the drum once maybe twice with some noise from the drum and then the LE comes on.Could the motor be bad or the bearings or both?
1 Answer Hello Dan. Based on the error code you provided, it sounds like the sensor 6501KW2002B is bad and will need to be replaced on the unit. Pull the unit out and remove the back panel. The stator motor is bolted to the back the washer with several bolts. Remove the bolt from the motor housing and you will see the bolts around the motor. Once the washer motor is off the sensor can be changed. Read More...
Glenn S. April 16, 2012 for Model Number WM1814CW I purchased the sensor but the connector to the control panel also needs to be replaced. I just can't figure out what the part number would be.
1 Answer Hello Glenn, The only way to replace a connector is to replace the complete wiring harness 6877ER1029A. This is controlled completely by the manufacturer. Read More...
Jerry April 08, 2012 for Model Number wm2277hs (LG washer) My LG Washer with front loads have an Error "tE" code and than stop working ?
1 Answer Hi Jerry. tE- HEATING ERROR • The THERMISTOR is out order. Thermistor part # 6322FR2046C. Make sure the cold water inlet valve part # 5221ER1003A screen is not clogged along with flushing out the hoses in a bucket. Thank You. Read More...
Robert October 03, 2011 for Model Number LG WM227H* Washer wont start shows error code PE worked the day before with no problem. Thank's for your assistance.
1 Answer Hello Robert. Check and see if the pump filter is clogged. If not and code continues, you will need to replace the pump assembly 4681EA2001T. Hope this helps. Read More...
Al May 27, 2011 for Model Number wm2487hwm Wash cycle interupted with pe error does not complete rinse.
1 Answer Hello AL. Check and make sure the drain hose is not to far inside the drain pipe causing the unit to siphon out. If it is good, you will need to replace the pressure switch 6601ER1006E. Hope this helps. Read More...
Terry May 12, 2011 for Model Number wm2277hw My LG frontload washer displays the code "LE" on the display panel after it loads with water, then shuts down. Is there a sensor not functioning correctly?
1 Answer Hello Terry. Here is waht the manufacture gives for the LE code. Hope this helps.• The connector (3-pin, male, white) in the MOTORHARNESS is not connected to the connector(3-pin, female, white) of STATOR ASSEMBLY.• The electric contact between the connectors(3-pin, male, white) in the MOTOR HARNESSand 4-pin, female, white connector in the MAIN PWBASSEMBLY is bad or unstable.• The MOTOR HARNESS between the STATORASSEMBLY and MAIN PWB ASSEMBLY is cut (opencircuited).• The hall sensor is out of order/defective. Read More...