Jw December 31, 2017 for Model Number SMH1927S/XAA-0001 When the door is open on our over-the-range microwave Samsung SMH1927S installed about 5 years ago, the range fan or motor starts, and the light turns on as if it was warming food. When the door is closed, the light and fan/motor stops as normal. Other than that, the microwave appears to be operating okay. We would greatly appreciate your recommendations, and if a replacement part will solve the problem. Also, is our problem a safety hazard when the door is open and it seems to be operating?
1 Answer JW, You will want to check the door switches on the unit and replace which one is faulty. Read More...
Jim December 18, 2017 for Model Number SMH1816S/XAA-0000 I would like to replace all three door switches while I have it apart.. I know I need the bottom one but need to know the part numbers for the other two.
Fred December 10, 2017 for Model Number SMH1816S/XAA-0000 The light comes on and the timer will count down but nothing else happens, from reading the other questions it sound's to be in the switches. Which ones do I need for this model. Thanks
1 Answer Fred, You will want to test the door switches for continuity. The upper and lower one should have continuity with the door open and no continuity with the door closed and the center will show open when door is open and closed when the door is closed and will be the monitor switch. Read More...
Doug M November 26, 2017 for Model Number SMH2117S With the door closed the microwave stays on. Doesn't heat or count down. When I slightly pull out on the top corner of door it will go off and operate normally. I figure it is a latch micro switch Part 28 on the diagram. or would I need the whole assembly with both switches. It seems like a easy fix with one switch. Thank you
1 Answer Doug, This issue would most likely be caused by a faulty microswitch 3405-001034. Read More...
Roberto September 15, 2017 for Model Number SMH1713S My question is that the microwave turns on the light makes the sound as if it was working fine the time it runs but it does not heat the food it can be Thank you
1 Answer Roberto, With everything working but not heating you will want to check the magnetron for a resistance of less than 1 ohm. If this checks ok then check the capacitor and the diode. If the resistance of the magnetron is not correct then this will need replaced. Read More...
Erik August 18, 2017 for Model Number Amana microwave AMC2206BAS06 When we open the door, the turn table begins to spin. Which of the three door switches controls this? Are they all the same type of switch and do I need to replace them all or just the one?
1 Answer Erik, The most likely cause for this will be the monitor switch part number 3405-001033. Read More...
Teody July 24, 2017 for Model Number SMH2117S/XAC If I plug in the microwave the breaker trips off. If the microwave is closed and I turn on the breaker, it works but if I open the door, the breaker trips off again.
1 Answer Hello Teody, This is most likely a door switch that is stuck in one position. You should replace all door switches to correct the issue. One 3405-001033 and two 3405-001034. Read More...
Sealgirl February 10, 2017 for Model Number SMH2117S Do not know if my model is XAA-001 or -002. Regardless, I need a new switch. Current switch that needs replacement is a Starion SZM-V16-FD-63 Normally Open. Ink stamp is 81618C. Markings on bad switch: 0.6A 125VDC 0.9A 250VDC 18A 1/2HP 125/250VAC T130 16A 250V-T130 5E4U Which switch would be equivalent?
1 Answer Hello Sealgirl, I"m sorry but appliances go b the model number and part description to locate parts. The markings on the parts are normally just vendor numbers that we cannot cross to anything useful. It does appear that 3405-001034 is listed on the parts list for the model number provided as a normally open switch . Read More...
Steve D October 12, 2016 for Model Number SMH2117S Can you tell me how to remove the old switch? They seem stuck. Thanks.
1 Answer Hello Steve. There are locking tabs on the switches that hold them in the switch holder. You will need to release those tabs and pull on the switch to slide it out of the holder. Read More...
Tony B September 13, 2016 for Model Number Smh1611w Door won't latch shut. Took out three switches . Two switches test zero Until orange button is pushed. And other one test + power until orange put is pushed & then zero power connection.
1 Answer Tony, The door switches are checking ok as this is how they work. For the door not latching it would be more likely the spring inside has broken from the latch. The spring part number would be DE61-00048A and the latch is part number DE64-00760A. In order to replace these you would use a putty knife and pop the inner door panel out and you will have access to the latch and spring. Read More...