Customer Questions and Answers for Automatic Washer (Direct Drive) - Whirlpool Repair Manuals by Whirlpool

Hello Robbie. To remove the agitator on this model, you remove the cap on top of the agitator by pulling up on it. Once this is removed you will have access to the innards of the agitator. Once the parts inside the agitator have all been removed you will see a bolt. Remove the bolt and the agitator will lift out. I hope this info helps.

Hello Rose! You will need to check your lid switch WP8054980. You should hear a clicking noise when the lid is being shut, this indicate the lid switch activates. You can also test the lid switch using a multimeter MA-DM1. Here is a link from our free repair forum you can refer to for help with using a multi meter. Hope this helps, thaks! http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html

Hello Tarheel68. Here is a link to our Repair Forum, this is a free service to our customers. Use this link to access the repair for your question. Hope this helps. http://forum.appliancepartspros.com/washer-repair/3265-replacing-direct-drive-washer-brake-shoes.html

Hello Richard. It sounds like you could have a bad motor, timer or a wire is causing a short. You will want to look at the wires going from the motor to the timer and verify it's not a wire causing the short. You can test the motor using a multi meter MA-DM1, you will want to touch each pin on the motor with one probe and the other to the casing of the motor. They should all read close to pass the test. The timer will be tested the same. Here is a link you can refer to for help with using a multi meter: http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html . Hope this helps!

Hello Jimmy! Unfortunately, we do not have the capacity information listed for your model LBR4221EW0. For this information you may be able to contact the manufacture. Thanks.

Hello Randy. Check and make sure you plugged the lid switch WP3949238 back in when you put the cabinet back toghther. Hope this helps.

Hello Rob. Sorry, we do not have the size of the washer and dryer. You will need to contact the manufacture. Thanks.

Hello! According to the manufacturer they listed this unit as a 3.2 cu ft. Thanks!

Sorry Jan but we were not able to locate the CU per ft for this unit. Most top loaders washer are rated at 3.0 cu ft. You can contact the manufacturer for specs. Thanks!

Hello Mary. Here is a link to our Repair Forum, this is a free service to our customers. Use this link to access the repair for your question. Hope this helps. http://forum.appliancepartspros.com/washer-repair/3265-replacing-direct-drive-washer-brake-shoes.html