Marlon M. March 13, 2014 for Model Number KFIS25XVMS1 My KitchenAid refrigerator needs W10213583C. Is there any cross reference number that will fit and work the same ?
1 Answer Hello Marlon! According to the appliance model number provided the HV Control board replacement available for your refrigerator is part number WPW10310240. Thanks! Read More...
Tom February 12, 2014 for Model Number GI5FSAXVY02 I have a Whirlpool fridge that in the fridge temp is 30 degrees, display on front is set at 46 degrees. In the freezer the display is set on 0 degrees but temp in the freezer is 16 degrees. Both was tested with a thermometer for a 24hrs. I have changed both Thermistors, one in the freezer and fridge. turn the fridge off damper goes closed, turn fridge on, damper opens. Do I need the main board W10310240 ?
1 Answer Hello Tom. If the unit is not reading the temp correct, and you are sure the thermistors are good, you will need to replace the control board in the unit. Read More...
1 Answer Hello Lonny. Make sure the freezer is between 0° and 5°. You need to check and see if there is power going to the water valve when the icemaker cycles. If so, replace the water valve on the unit. If not, or the icemaker does not cycle, you will need to replace the icemaker on the unit. Also, check and make sure the fill tube on the unit is not frozen and clogged. If so, replace the water valve and thaw out the fill tube. You can test this with a multi-meter TJMA-DMT3. Here is a link on how to use a multi-meter. http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html Read More...
Kt January 30, 2014 for Model Number Whirlpool Gold French Door GI5FSAXVY02 Hello, I have a whirlpool gold refrigerator model GI5FSAXVY02. It was put into service about 1/15/2011. The ice dispenser will not operate.(The ice maker is making ice)when I push the button for ice all the lights light up. The water dispenser operates fine, the refrigerator temp will only lower temp. Refrigerator is at 39 degrees. Called whirlpool and they had no idea what was wrong. Any ideas? Thanks KT
1 Answer KT, The most likely cause for the display not working properly and the dispenser not working for ice would be a faulty Display board WPW10162500. Read More...
Patrick January 18, 2014 for Model Number AFI2538AEB3 The water dispenser, ice dispenser, panel display, ice maker, and interior lights all don't work. The refrigerator and freezer cool normally, however. Is this W10310240 board what I probably need to make the repair?
1 Answer Hello Patrick. Test for power to the dispenser. If none is there, replace the HV board. You can test this with a multi-meter TJMA-DMT3. Here is a link on how to use a multi-meter. http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html Read More...
Rita December 17, 2013 for Model Number MF12269VEQ1 The controls on the icemaker and water just beeps when you touch the buttons. It is not locked, but can't figure out what part I need. Can you help? Thanks
1 Answer Hello Rita. If beeping, the membrane is good and you will need to replace the L.V. Board 67006294 in the unit. Read More...
Steve November 30, 2013 for Model Number giofsaxvy02 It stopped working last night. The controls on the door stopped also no power to the digital readout, compressor does not run. I know i have power, lights inside work. I have the back off don't see anything wrong. I think it is the control panel? Thanks Steve
1 Answer Hello Steve. If there is power to the main board and the controls are dead, you will need to test for power to them. If it is there, replace the controls. If not, replace the main board. You can test this with a multi-meter TJMA-DMT3. Here is a link on how to use a multi-meter. http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html Read More...
Craig November 24, 2013 for Model Number gi5fsaxvy00 Cannot move refrigerator temp up or down, freezer temp will go up and down, will not switch from ice to water. when trying both of these functions, 4 lights light up. 2 red and 2 blue. refrigeration cooling off light, filter replace light, lockout light, and the light on light. Do you think this would be the main control board? Thanks in advance!
1 Answer Craig, The issue with the unit not dispensing and not adjusting the temp would most likely be caused by a faulty control board WPW10310240 if the unit's child lock is on. Read More...
Dennis November 15, 2013 for Model Number MFI2569VER Food is freezing in fridge put new thermister in and still freezes. Fan in fridge runs all the time.
1 Answer Hello Dennis. It sounds like the damper assembly is bad and will need to be replaced in the unit. Read More...
John October 22, 2013 for Model Number GI5FSAXVY02 The control panel for selecting the ice or water does not work. It is stuck on water won't switch to ice. Also you can move the refrigerator temperature down but up won't work. The other touch buttons work fine. I looked at the control board and it does not have any burn marks. It looks fine. On the plastic cover it lists part number W10256912. Which does not seem to match up with any part. Do you think this part is the issue?
1 Answer John, With the keypad not responding the issue would most likely be in the keypad itself. The part number that you would need is part number W10740218 Read More...