Robin December 05, 2011 for Model Number 11029422800 My Kenmore Washer is 18 Months Old, it fills with water but won't Agitate, Drain or Spin. The drive motor doesn't run and the washer makes a brief buzzing noise then shuts off. Nothing is stuck between the inner & outer tub and the pump, drive motor (shaft turns freely in both directions) motor coupler & drive block are fine. Therefore, I need instruction's on how to check the Capacitor and Motor Switch (P/N 3952056) for Continuity/Ohm's & AC/DC Voltage?
1 Answer Hi Robin. When a washer fills up with water and stops, it awaits for the lid switch to close. Part # WP8318084. Thank You. Read More...
Ryan July 28, 2011 for Model Number 110.14212200 The washer does not fill or rinse. The pump and the inlet lines look clear, and the pump spins freely. Spin cycle still works so the motor seems to still work. It first started when the washer would stop at the rinse cycle, but would still fill and wash. Now it doesn't fill or rinse, only the spin cycle works and it does expel the water. What could be the problem?
1 Answer Hi Ryan. Is The water valve humming while trying to bring in water? The water valve is part # 285805. If It does not hum then replace the timer with part # WP3953935. Thank you. Read More...
Elvin L. July 07, 2011 for Model Number 110.46472500 How I can get the tech sheet thru internet? I lost mine. Kenmore 110.46472500. Thanks. Elvin.
1 Answer Hello Elvin. We do not have the tech sheet for the model number you provided. You can post your question on our repair forum and see if any of the technicians have one. Here is a link to the repair forum. Hope this helps. http://forum.appliancepartspros.com/ Read More...
Elvin Lopez July 07, 2011 for Model Number 110.46472500 On any cycle the water goes in. But the washer is not washing, it's not tumbling. There is no drain or spin cycle as well. ELVIN. KENMORE model number 110.46472500 . THANKS.
1 Answer Elvin, On a front load washing machine, and with the issue you're describing, You want to check the door latch switch assembly and wiring first, WPW10253483 . What lights are on, and what appears in the display when you start the washer ? Your Tech Data Sheet should be located inside the washer cabinet, behind the lower access panel, and you should be able to program test modes and component tests, and repair the washer in little to no time. Good Luck. Read More...
Elvin L. July 07, 2011 for Model Number 110.46472500 On any cycle, the function of wash not working . The water added then drained, but not tumbling. Kenmore 110.46472500. Elvin. ELVIN. THANKS.
1 Answer Hi Elvin. First turn off all power. Then inspect the motor, motor control board, main machine control board and user4 interface panel for any wires / connections that might be loose. You have lost communication between motor and main control board. Look under your top and follow the technician sheet to put the machine into the field service test to tell you what specific area of failure you need to check. You might have something clogging the pump as well..Let us know if we can assist further. Thank you. Read More...
1 Answer Hi, unfortunately we are unable to tell you the capacitance of this capacitor. We cannot tell you if the capacitor is faulty or working properly. Thanks! Read More...