Customer Questions and Answers for Run Capacitor by Whirlpool

Hello Anthony. You will need to test the defrost thermostat WPW10225581. It should read closed for continuity when cold. If it is good, and you have replaced the heater, you will need to replace the defrost control board WPW10366605. You can test this with a multi-meter TJMA-DMT3. Here is a link on how to use a multi-meter. Hope this helps. http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html

Hi John. There is a compressor relay/overload that is for your refrigerator. This part # is 4387913. Make sure your condenser coils are clean. Thank you.

Hello Tony. Based on the information you provided, you will need to replace the start device WPW10189190. Hope this helps.

Hi Dave. You have some kind of direct short. Provide us with the correct model and serisl # as we can assist you further. thank you.

Hello Victor! To verify the exact matching part for your unit we will need the appliance model number. Thanks.

Hello Lenny! The run capacitor for model 10654613300 is part number WP4387764. Thanks.

Hello Mike. If the starter is bad on the compressor, then here is the part you will need 8201786. Hope this helps.

Hello Joe. It should be ok to use the 15uf in place of the 12uf on your refrigerator. Hope this helps.

Hello Dan. This works in conjunction with the start relay. If you will provide your model number, we will be glad to look up the part for you. Thanks.

Hello Rich, You will need a capacitor tester to truely test this part. Some meters have these on them, and some do not. Hope this helps.