Dave Z. September 23, 2011 for Model Number MDBH955AWS3 I Have a maytag model # MDBH955AWS3 Dishwasher that does not turn on, press any button on the control panel (key pad) and nothing happens, check power 120v out of the door latch sw's and is there. How can I isolate the problem from the control panel or the control board, is there any way of testing these units? and also what's your policy on returns if i order the control panel??? thank you in advance.
1 Answer Hi Dave. If you have already verified the correct 120 vac from the switch to the control board and there is no reaction, then you will need to check to see if the float switch is being activated correctly by the float stem resting on the float switch. Is the switch sending 120 vac to the water valve? Some times the float stem will come off the switch or the water valve screen gets plugged or the water valve solenoid does not open. Water valve is part # W11082871. The control board is part # WPW10218837 if you do not get 120 vac out to the water valve. Thank you. Read More...
Steve September 17, 2011 for Model Number MDBTT60AWW serial # 32635019JC Which control board do I need?
1 Answer Hello Steve. Based on the model and serial numbers you provided, 12002709 is the correct control board. Hope this helps. Read More...
Alison August 15, 2011 for Model Number MDBH965AWS Hi there, my Maytag dishwasher does not start when I press the start button on the control panel. Some lights (kind of random) are on when the door is closed. The serial number is 10879742GJ. Do you think the problem is with the control panel or the control board? And which part # should I pick? Thank you.
1 Answer Hello Alison. Based on the information you provided, it sounds like the control panel 6-919836 is bad and will need to be replaced. Hope this helps. Read More...
Kurt August 03, 2011 for Model Number MDBTT60AWB My dish washer is constantly switching from normal wash to rinse only. Would this be a problem with the control board and if so which board do I need? My washer is a maytag and the model # is MDBTT60AWB and the serial # is 10893877GT.
1 Answer Kurt, Do not start with the control board, it's the lesser of the possible problem. You're more likely issue is in the control panel keypad assembly 6-919844 . After a few years of wear & tear, and usage the circuit for the keypad and the membrane assembly weaken and starts to fail. Good Luck, and Thanks Read More...
Mike S. July 12, 2011 for Model Number MDB5601AWB 37165752NA I think the control board has gone bad. Unit is a bit over 3 years old. When door is open, three panel lights flash: normal wash, start/cancel, and hi temp wash. Close door and lights stay on without flashing. Sounds like pump is running continuously and the heater is on. Start/cancel does not reset. Flipping the breaker off for 10 minutes then on does not reset. It ran for at least 30 minutes before I discovered it having a problem. Is it also possible that the pump or heater may have suffered damage?
1 Answer Hello Mike. Based on the information you provided, it sounds like the control board 12002709 is bad and will need to be replaced. The pump and heater should be ok. You can test the heater W10283681 and see if it is good. It should read closed for continuity. You can test this with a multi-meter TJMA-DMT3. Here is a link on how to use a multi-meter. Hope this helps.http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html Read More...
Chris July 12, 2011 for Model Number MDBH955AWS I have this model dishwasher. My buttons light up when I push them but the dishwasher wont start. Then sometimes the lights on the buttons jump around. I'm assuming this is a control board issue but I wanted to be sure I was going the right direction and also be sure which part # I need.
1 Answer Hello Chris. Based on the information you provided, it sounds like the control panel is bad. You can remove the ribbon cable from the control board and clean it. If the problem continues, you will need to replace the control panel. Based on the model number you provided, 6-920244 is the correct control panel. Hope this helps. Read More...
1 Answer Hello Bnort. Accroding to your serial and model number, WPW10218837 is the correct board for your unit. Hope this helps. Read More...
Bnort April 17, 2011 for Model Number MDB6601AWQ The parts list shows two different parts for #7. How can I tell which one I need?
1 Answer Hello Bnort. If you will send us your serial number, we can determine which part you will need. Thanks. Read More...
1 Answer Hello. Here is the part number for the model you provided.12002709 Hope this helps. Read More...