Pat V. December 06, 2011 for Model Number MDBTT53AWB1 This dishwasher will not turn on. Power to the unit is good. Control panel only has 2 lights that come on (high temp wash and heated dry). All other lights do not go on.
1 Answer Hello Pat. Based on the information you provided, it sounds like the control panel W10810104 is bad and will need to be replaced. Hope this helps. Read More...
Matt November 23, 2011 for Model Number Mdb7759awb0 Will this part remedy the blinking lights issue? Dishwasher doesn't work!
1 Answer Matt, You're blinking light issue is more likely due to a faulty keypad / control panel WPW10199788. " PROBLEM: Won’t Run and LED Above Key(s) is Flashing Rapidly Short circuit(s) in keypad or in control’s input lines that read the keys. Don’t replace both: See first section of “Checking Keypad Operation” for test to determine whether shorts are in the keypad or the control. CHECKING KEYPAD OPERATION A rapidly blinking LED over one of the keys of the keypad (or sometimes a “dead” keypad/console) indicates one or more key switch lines are stuck or shorted on either the control or the keypad. To determine if the control or keypad is faulty, do the following test: 1. Unplug dishwasher or disconnect power. 2. Open the dishwasher door. 3. Open console and disconnect the keypad ribbon connection from the control Make sure all other connections are made. 4. Put console back together. Do not close the dishwasher door. 5. Plug in dishwasher or reconnect power. 6. Wait 5 sec. 7. Close dishwasher door. 8. Monitor the control’s response: ?If the control is OK (no longer sees shorts with the keypad unplugged), it will respond by turning on the Drain Motor for 2 minutes. Check and/or replace the keypad if the control responds OK. ?If the control is not OK (still sees shorts with the keypad unplugged), then the drain motor will NOT if the drain motor does not start within 10 sec, repeat or verify that all the steps were followed, then replace the control." Thanks and Good Luck Read More...
Dan November 03, 2011 for Model Number gu2275xtvy1 Lost power,used generator and think i fried control panel smell electrical burn from dishwasher could it be thermo fuse or panel?
1 Answer Dan, I would hope it'd be a thermal fuse W10258275 , but it's probably not. It's most likely the electronic control board WPW10285180 . Using a generator, even in an emergency situation, wreaks havoc on control boards and systems, due to the voltage, amperage and wattage fluctuations the system generates. Thanks and Good Luck Read More...
Bill November 01, 2011 for Model Number 66513242k900 Will the inner panel have to be removed to access the control panel? Are there any tips or advise listed to aid quicker replacement? Last do you have a exploded diagram for the door?
1 Answer Hello Bill. Yes, you will need to remove the inner door panel and disconnect the power to replace the control WPW10285180. Hope this helps. Read More...