Laura September 17, 2018 for Model Number KUDS24SEBL2 My KitchenAid dishwasher model KUDS24SEBL2 control panel flashes child lock with no other lights on. The dishwasher does not respond to pushing of the cancel button nor the Energy Saver Dry button normally used to release the child lock mode. The dishwasher does not come on when you hit start and does not respond to any button selection on the panel. I am thinking this is an electronic control board issue. Would you agree or is there some other explanation or part failure? If I open the dishwasher door and close it again, the child lock light goes off momentarily and the washer starts to make a running noise but then stops within 30 to 45 seconds and the light starts flashing again. If it is the electronic control board, I am looking for a part to replace it with. Whirlpool no longer makes or sells the part; original part # WP8051136. Thank you for any advice and help you can provide. Laura
Laura September 17, 2018 for Model Number KUDS24SEBL2 Do you sell an electronic control board, manufacturer part number WP8051136 for the kitchen aid model KUDS24SEBL2 which is no longer available from the manufacturer?
1 Answer Laura, Unfortunately with the control board WP8051136 having been discontinued there would be no suitable replacement available. Read More...
John S. December 12, 2014 for Model Number KUDS24SEBL5 I just purchased a new console but not the insert, thinking I could simply take the insert out and put it in the new console. It looks like, however, the insert was glued into the old console. Is that a common practice? Or is there some trick to removing the insert? It doesn't even budge/move no matter what I try.
1 Answer Hello John. The insert is glued to the console. Use a putty knife and pry the insert from the console and stick the new one into place. Read More...
Ronald H. February 17, 2012 for Model Number kuds245ewh1 I ordered a control panel insert (ap2920946) around Christmas. I removed the defective one, cleaned and dried the panel and installed the new insert. About 1 week ago, the insert, left side only, seperated and drooped and could not be reinstalled. Why would a new insert adhesive fail so quickly and is there any warranty on the one I purchased? I tried using a spray adhesive but could not prevent air pockets under the insert.
1 Answer Ronald, I do apologize for the issue you are having with the part you received from our comapny, we have a one year warranty available on our parts. Here is the link for our warranty process. Thanks! http://www.appliancepartspros.com/customerservice/warranty.aspx Read More...
Mark December 09, 2011 for Model Number KUDS24SEWH4 How is the touchpad removed and/or installed on the new console?
1 Answer Hi Mark. These are easy to replace, just un-peel the old insert off the control panel. Then stick the new insert WP9743375 onto the control panel on the unit. Read More...