Customer Questions and Answers for Replacement Icemaker by Whirlpool

Hello Jerry. No, you will need to make sure the freezer temp is 0-5°. If not, then the icemaker will not cycle properly.

Hello Robert, The arm is not included because there are so many shapes of bale arms for the icemaker assemblies, it is not possible to include them all with the assembly. If you could please post a new question which includes the model number of the unit the icemkaer is to be installed in, we can check to see if the bale arm configuration for that model is available individually. Thank you for your patience and understanding in this matter.

Hello Justin. About 1 time an hour is normal. This is all they are designed to do. Thanks.

Doris, You will want to make sure that the fill tube is not frozen up going into the icemaker. If this checks ok then this issue will most likely be caused by a faulty water valve.

Mildred, The part number for the door bin will be WP2187172.

Hello Robert. Make sure the freezer is between 0° and 5°. You need to check and see if there is power going to the water valve when the icemaker cycles. If so, replace the water valve on the unit. If not, or the icemaker does not cycle, you will need to replace the icemaker on the unit. Also, check and make sure the fill tube on the unit is not frozen and clogged. If so, replace the water valve and thaw out the fill tube. You can test this with a multi-meter TJMA-DMT3. Here is a link on how to use a multi-meter. http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html

Rene, The part number for the icemaker assembly for your unit will be W11700559.

Steve, You will want to check the water line to make sure that it did not get kinked and that the water is on. Also check to make sure the wires for the water valve are not disconnected.

Rwego, You will want to check to make sure that there is power going to the dispenser motor. If the motor is getting power then the issue will be a bad motor.

Jesus, You will want to pull the icemaker out and check to make sure that the fill tube is not frozen over. If it is then clean out the ice and it should work. If not then check the thermal fuse on the icemaker wire harness for continuity. If there is no continuity then the harness is faulty and would need replaced. The part number for the harness is WP61001882.