Customer Questions and Answers for Suspension Spring by Whirlpool

Hello Alexander, thank you for contacting AppliancePartsPros.com All LSR8233 models use 3 of suspension spring WP63907.

Hello Dan, thank you for contacting APP, Usually, you can press down on the tub until it bottoms out and then release it. If the tub comes right back up or only bounces once then the suspension is good. If the tub wobbles and bounces more than that when released the suspension needs to be replaced.

Ed, the suspension rod kit W10780045 would be used with the model number provided.

David, the model provided uses three suspension springs WP63907 and one counterbalance suspension spring WPW10250667.

Jennifer, the model would use three suspension springs WP63907 and one counterbalance spring 285901. However, when these springs fail, it would cause the unit to shake around only during the spin cycle as it would be spun out of balance.

Marschal, We will need to have the model number of your washer to be able to assist with your question.

Daniel, Thanks for the question!!! One WPW10250667 and three WP63907

Sylvia, You will need to remove the outer cabinet of the washer and there are three points where the springs are attached and they look alike. Locate the three and find the one the spring is missing from.

Krisi, A proper model number so we can verify the parts needed and advise you properly would be a better help. If the washer is leveled, the rear legs are "locked" in place and you're sure everything else is OK then you would also need to check the 285219 Suspension Pad Kit and the WP3946509 Skate Plate. If the tub shifted or moved due to moving the machine or an extremely large off-balanced load the pads or the skid plate could shift out of position and get "locked" up and cause the washer to vibrate badly because the tub can't move as freely as it should.

Curt, You probably have a leak in the fill tube. WP3357328 Watch the video linked to this part to find out how to gain access and inspect the part.