Sharlotte October 18, 2013 for Model Number WED8300SW1 I need to replace the control board on my dryer. You have given me the part, now I need directions. Do you also provide directions? I am very capable.
1 Answer Hello Sharlotte. We will need your email address to send you the directions. Thanks. Read More...
Bradley A. May 02, 2013 for Model Number WGD8300SW2 I recently cleaned out all of the duct hose, and removed a significant amount of lint. When I plugged the dryer back in it ran , but only cold air. I've been told that a part was probably fried due to the constant turning on and off of a heating safety element that was detecting restricted airflow and it eventually died out. Do you know what this part may be? Thanks, Brad
1 Answer Hello Bradley A. You will need to test the thermostats and the flame sensor and make sure they are good. They should read closed for continuity. Also, check the igniter and make sure it is getting hot enough to light the gas. Here is a link on how to use a multi-meter for the testing procedures. http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html Read More...
1 Answer Amanda, your model WED8300SW1 uses user interface electronic control part number WP8571955. If you are needing the board down inside the cabinet you will use part number WPW10111606. Thanks! Read More...
Amanda March 06, 2013 for Model Number wed8300sw1 My dryer turns on but when you puch start it doesnt do anything. It shows f 01 code. What could this be?
1 Answer Hello Amanda. F-01 flashes when there is a primary control failure. Replace the machine control electronics. Read More...