Range Hood Gasket & Seal

This is a genuine OEM replacement o-ring sourced directly from the manufacturer for use on range vent hood switches. The o-ring provides a tight seal for the switch and keeps smoke from escaping through the switch connection. If the o-ring becomes worn or damaged, the vent will not remove smoke during cooking and should be replaced. Heat and debris pulled through the vent may cause the o-ring to warp. O-rings are not designed to last forever and may need to be replaced during the life of the appliance to keep it functioning correctly.To start, disconnect the power to the vent hood and dismantle the vent in order to reach the switch. To start, disconnect the switch and locate the o-ring. Remove the old one and dispose of it. Place the new o-ring in the groove and press firmly to seal the part. Lubrication is not necessary for installing the new o-ring. Reassemble the switch and put the vent hood back in place. Connect the power and try the switch to make sure it works. This o-ring is made of heavy-duty black rubber is and sold individually. It is designed for use in range hoods manufactured by Thermidor.

This silicone adhesive-backed seal replaces a worn or damaged dishwasher door/tub perimeter gasket to restore a tight seal and reduce leaks and dampness around the door. Flexible silicone resists common household temperatures and moisture. What it does:

• Forms a watertight barrier around the dishwasher door/tub edge to help prevent leaks during cycles
• Adhesive backing allows the seal to stick in place for consistent contact and reduced movement
• Commonly used when the existing gasket is cracked, flattened, torn, or no longer sealing
• Helps reduce water pooling, floor damage, and poor wash performance caused by door leaks

• One silicone adhesive-backed seal (33.75 in.)

• Clean and dry the mounting surface thoroughly before applying to ensure proper adhesion
• Peel backing and press seal into place, working slowly to avoid gaps or twists
• Trim excess if necessary with a sharp utility knife; avoid stretching the gasket while installing

This replacement door gasket provides a flexible, airtight seal for refrigerator doors to help maintain proper cooling and reduce moisture intrusion. Designed to restore door sealing performance and help prevent temperature loss. What it does:

• Seals the door perimeter to keep cold air in and warm air out
• Helps reduce frost build-up and interior moisture
• Can improve cooling consistency and energy efficiency when the original seal is worn
• Common symptom: visible gaps, torn or hardened gasket, or excessive condensation around the door

• One replacement door gasket

• Disconnect power to the appliance before attempting replacement
• Remove the old gasket and clean the mounting surface of debris and adhesive residue
• Align and press the new gasket into the door channel, working around corners for an even seal
• Check the seal after installation and allow the gasket to settle; adjust as needed for a snug fit