Roper Dishwasher Valve

• Will not fill with water
• Noisy

Recently my Kenmore dishwasher would start but would not fill with water. A quick test of the float switch reflected proper operation, AND voltage was being delivered TO the contact on the water inlet valve. I then removed power and checked for continuity on the contacts. This read “infinity” (Open circuit) which indicated a break in the coil inside the valve’s solenoid. As such the valve would not open to allow water to flow. I ordered the replacement water inlet valve from... Read more

Dishwasher washer would not drain after hearing glass-like particles during the drain cycle despite trying to clean the cylinder filter. Originally suspected the drain motor was damaged. After watching a video on how to replace the drain pump, I carefully energized the dishwasher (from water and electricity) then removed the dishwasher to take a look. After removal of drain hose from the pump, discovered that drain hose was connected to water inlet assembly which also needed removal to... Read more

• Will not fill with water

First I cleared the food chopper area. There were things there, bits of plastic for instance, but it wasn't the reason for the dishes not getting sprayed off. The dishwasher continued to only partially fill and not circulate the water. I started the dishwasher, let the pump start and then opened the door and filled up the dishwasher manually. It sprayed water as it should, cleaning the top rack quite well. I figured the issue was not the float switch, since some water was coming in. So I... Read more

• Will not fill with water

Ordered new inlet water valve and float switch kit. After repairs it now works fine. However the water inlet valve outlet end for fill hose (not water source) and wire connections (supposedly for this unit) were oriented 180 degrees opposite. I had to gently remove the blue plastic valve off the metal support bracket and turn it around and press back in place. Fortunately it appears it was designed for either orientation. Also the solenoid had to be unclipped and also rotated. Again it was... Read more

The odor in the dishwasher was due to scum buildup in the walls, the racks, and in the lower part of the drain below the lower rotating arm. One of the valves in the vertical tube was stuck in the open position; since the valves cannot be replaced, the entire tube needed replacement. The check valve probably needed no replacement, but once I opened the bottom part, I decided to replace it anyway. I used this Youtube video to replace the tube, open and clean the drainage part of the washer: ... Read more

• Will not drain

I checked the drain hose for blocking at the garbage disposal and then at the connection point to the dishwasher. The hose was clear and nothing was obviously obstructing where the drain hose connects to the dishwasher. At this point I Googled the model number with the term "will not drain" and immediately landed on the AppliancePartsPros.com website. At the Drain & Wash Impeller Kit page amazingly had a video showing the technician replacing the impeller on a dishwasher essentially the same as... Read more

I cleaned all the jet nozzles with a toothpick and a pipe cleaner to remove the hard water deposits. I then replace the ring bearing under the bottom spray wand and the ring bearing under the upper spray wand. I also replaced the smaller radial ring bearing. Although none of them looked overly worn, it doesn't take much to cause the spray wands to spray inadequately. Then, I replaced the float and washer assembly. Although it appeared to work properly when I lifted up on it and let it down, it... Read more

Replace the motherboard and used YouTube to replace float switch. Part ordered was exactly what I needed Read more