Roper Refrigerator Parts

After tossing a couple for refrigerators to clean the storage area - we had one good one left taken from an apartment where the resident bought a newer-bigger one. Another resident's went bad - froze in the freezer - but 65 F in the lower refrigerator unit. Not my job but I decided to check it - diassembled the freezer plastic - fan didn't run - took it out and direct powered it - dead! I went on line and reviewed numerous Goolgle hits - yours was easiest to work in - put in the OEM P/N - you... Read more

I replaced the freezer door seal. Read more

Although the solenoid I purchased did not fix the problem, nor the "mother electronic board", or the motor, my experience with Appliance Parts Pros has been excellent. Extremely easy to look-up parts for my model refrigerator. Best part is their video instruction that gives you step-by-step hands-on how to remove and install. I would highly recommend these folks. If a lady such as myself can do repairs based on their instruction, anyone can. Thank you for providing such an informative... Read more

I looked at a video on YouTube and followed the instructions. Read more

Well, I took it out (it slides out) to get a good look at it,so i could ref pictures on your site..naturally I had serial/model of refrig,and thats mandatory to get the right part. It came in 2 days,,and being just the bucket, it took only a few minutes to transfer the auger assembly/cube/crusher.... into the new one, 6 screws total..Your site has excellent vids on DIY.......I HIGHLY reccomend. Whole process was'nt over 15 minutes, piece of cake....And NOW i can go back to my nightly 'scotch... Read more

• Ice maker won't dispense ice

I first thought it was the auger in the ice container so I changed it and it was not the problem. I then talked to ApplianceParts customer service that it might be the yoke on the motor that turned the auger or even the motor itself even though it worked. I ordered the parts, the yoke was supposed to be able to be changed by itself but mind would not come off the motor shaft so I had to cut it off just to remove it from the unit so I had to change the motor anyway because of this. So I advise... Read more

Installed it according to video watched. Read more

The 20 year old unit still serves us well, looks good and has been kept in good repair. The condenser fan had stopped so I removed, cleaned and oiled that motor. The decision was made to make an upgrade to the evaporator motor and control units so that the appliance could reasonably be expected to have extended service life. The Ice maker module had been replaced 7 years ago. I ordered the parts and have made the upgrade for temperature controller and the defrost control. If you are in a... Read more

The drying agent lid was broken for a couple years now and our dishes would never dry completely. We finally decided to google for Kenmore parts and this website came up. Couldn't believe how easy it was. All we had to do was find the brand and model number and all the parts showed up on Appliancepartspros.com website. We scanned thru the list found the lid and ordered. It arrived within 2 days. Viola!! Now we wish we had done this much earlier. Thank you for such a smooth experience. Read more

The refrigerator was given to me and hasn't defrosted since it was new. I found the defrost timer had a burnt spot on the circuit board. After installing a new timer, the refrigerator would trip the circuit breaker in my house when it entered defrost mode. I found that the pink wire running from the control board all the way to the thermostat was shorted somewhere between the two parts, inside the refrigerator. I ran a new "pink" wire and all is good. Read more

• Won't start
• Fridge too warm

Took access panel off the back of the refrigerator with 1/4 inch nut driver and found that the compressor was not running properly (humming and hot but not compressing). The compressor cooling fan was working as well as the fan in the freezer compartment. I fixed the same problem with another refrigerator by replacing the relay and start capacitor on the compressor. I pulled these two items from the compressor connector (gently pry the brown part from the comp terminals first and then the... Read more

Put the new hinges on the doors fyi you need to tell what size the screws are for the hinge kits would help a lot Read more

Replaced filter housing, and both water tubes Read more

Ordered new crisper, cover, and new crispers Read more

I purchased a freezer gasket + key// from appliancepartspros.com //easy to order. I did not need to lock up my freezer but thought it might help the gasket seat (good thought). To replace gasket I started at top of door, wow, I should have started at bottom. Hated laying on my "belly" to screw in gasket. Ok, I am 77 years old but got the job done. All went okay until I had to close the door, the door would not stay shut. Key: I locked the door for a week. New seal is settling in, freezer is... Read more

Buy a new door shelf bar! I ordered it and two end caps (I didn't know the things existed) and shortly the package came from Appliance PartsPROS.com. In a matter of minutes I had a shiny new shelf bar and vavoom the refrigerator was as good as new! No more juice, milk, or soda cleanup on the floor! Thanks for your good service with the video, also. Read more