Samsung Dishwasher Gasket & Seal

• Leaking

I just had to pull the old out and push the new one in. Read more

We replaced the Tub Seal. Read more

Since my Samsung Dishwasher would not drain and had a flashing quick light, I removed the racks and both spray wands. Which allowed me to remove the lower screen assembly. This revealed a worn and broken check valve and broken grinder blade. I cleaned the inside of the dishwasher and removed the unit from under the counter. I removed and cleaned the brake assembly ( large transparent plastic section on left side of the dishwasher). I cleaned this for preventive maintenance by taking the float... Read more

After researching the Internet, I thought the drainage hoses were my problem. First I changed both drainage hoses. That didn’t solve the problem. I had to look for another area that was causing water to drip into the pan. I found water leaking from behind the brake assembly. Since I didn’t get an oE error code, I eliminated the brake assembly as causing my problem. I ordered a brake gasket and cover. Once I got it properly installed, problem solved! Read more

• Leaking

I ordered a new rubber door seal for around door, new bottom door seal and spinner impeller and nut to hold on bottom arm as it looked weak. Everything worked great except bottom door seal which looks slightly different and would NOT stay on. I ended up putting back on the old one. Door doesnt leak but not sure it would even be worth it sending part back as I already tossed bag out. Other parts worked great and DW cleaning better. Read more

Research indicated that it may be a moisture sensor failure or a leak. It ended up being a leak from the oil seal on the motor shaft. A small piece of plastic made it's way into the system. The hot water softened it enough that it wrapped around the motor shaft, re-hardened, then tore into the shaft seal. I fixed it by replacing the shaft seal, moisture sensor (corrodes when it gets wet), and replaced the sump seal since I had it disassembled. Read more

While waiting for a replacement PCB, I cleaned the filter and soaked up the remaining water in the tub (dishwasher died mid-cycle) which entailed removing the dishwasher mesh filter and cover assembly of the pump assembly. The filter seal in the cover assembly and seal in the case scroll popped out. These two gaskets (seals) somehow had stretched and were very difficult to keep in their tracks while reassembling the pump assembly after cleaning. Replacement gaskets fit much better than the... Read more

Research indicated that it may be a moisture sensor failure or a leak. It ended up being a leak from the oil seal on the motor shaft. A small piece of plastic made it's way into the system. The hot water softened it enough that it wrapped around the motor shaft, re-hardened, then tore into the shaft seal. I fixed it by replacing the shaft seal, moisture sensor (corrodes when it gets wet), and replaced the sump seal since I had it disassembled. Read more

Replaced the gasket. Read more