Giovanni C Richmond Hill , GA August 22, 2015 Appliance: Samsung Range FTQ353IWUX/XAA-0000 The burner on my samsung range would only heat high regardless of the knob position I replaced the power regulator on he affected burner. Took ten minutes - killed the power removed 5 screws on the back cover, swapped wires to the new regulator block, unscrewed the old block screwed in the new in and replaced the back cover. Only needed a Phillips screw driver. Took longer to clean the dust bunnies behind the range, YUCK! Remember the regulator for the single ring and the double ring burners are different, make sure you get the right one. Read More... 83 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Screwdrivers
David M North Kingstown , RI December 08, 2015 Appliance: Model FTQ3531WUX Front burner was always on high heat when turned on Replaced front burner switch module. Read More... 11 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Pliers, Screwdrivers
Victor V Harleysville , PA July 26, 2018 Burner not working. Replaced heating element. Read More... 5 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Screwdrivers
William B Bradenton , FL March 21, 2018 Burner control switch not regulating burner properly. Replaced burner control switch. Read More... 1 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Screwdrivers
Frank F Felton , DE May 22, 2017 My samsung range wasn't regulating the heat on the stove top two burners would stay on high heat regardless of the selected temp selection After I received the replacement parts (4 regulators/stovetop) I unplugged the range and removed the top back panel. Next was the removal of the control knobs on the range front and the removal of the mounting screws, then from the back disconnecting the regulators was easy. I replaced each connector in sequence with the replacement part, repeated this with all the control units then replaced the mounting screws and knobs and replaced the back panel. Total time for the repair was less than 30 minutes, that is because I replaced all 4 of the burners regulators together. Read More... Do-It-Yourself Rating: Repair Time Estimate: 30-60 minutes Tools: Pliers, Screwdrivers