1066215900 Parts

I have a Jennair jjw9630cas double wall oven, and after a few years I noticed that the light would not go out, first in the bottom oven, and then in the top oven. After doing some research I discovered this was not uncommon, and the fix usually involved replacing the hinges and/or the hinge receptacles. It didn't look like a difficult fix so I ordered four new hinges and four new receptacles, which arrived quickly. I found a video on YouTube that showed how to replace the hinges and it... Read more

• Too warm
• Clicking sound
• Won't start
• Freezer section too warm

I have a Kitchen Aid side by side refrigerator/freezer which is 8 years old. One day it just stopped cooling. At first I was just going to junk it and purchase a new one. However, I took off the lower back cover and noticed the compressor was not running. I knew from experience that these compressors need a starter capacitor and relay and it is not uncommon for these parts to fail. I looked on the Internet for a video which showed how to remove the parts. I also found a video which showed how... Read more

• Frost buildup
• Freezer not defrosting
• Freezer section too warm
• Fridge too warm

Condenser was encased in solid block of ice due to automatic defrost not working. Replaced thermostat and ADC control board. Working fine now. Most tedious part was using a heat gun to melt all the ice off the condenser coils. You will need a couple small wire nuts to splice the new thermostat into the existing harness (they are not included). Service tech wanted over $400 to repair, fixed it myself for half that. Thanks ! Read more

Top mounted freezer with bottom refrigerator. Kenmore Elite Shut off the power Remove all food stuff from freezer (placed in ice chest) then shelves. Removed the ice maker, (easy!) 3 screws and unplugged wires. 2 screws in the back panel. Pulled top forward - downward Unplugged wiring harness from back wall of freezer, removed ground wire from panel Pulled fan blade off. (Fan was attached to back wall, not removable back panel) Removed 2 screws to get to fan motor. 'Unsnapped ' motor... Read more

Replaced door switch - it took less than 5 minutes - works perfectly Read more

We watched a "youtube" video on how to fix a fridge door seal and even though this particular model fridge was not the same...it helped to see how to fix it. It took me 20 minutes to remove and replace the new door seal. The part ordered was ordered and delivered next day which was great!! Read more

• Fridge too warm
• Noisy
• Freezer section too warm

I google the problem. So thankful I found your site. My husband is not handy at all. Your video made the process very manageable. Ordering process is a breeze. I chatted with customer service before ordering and everything went smoothly. I'm telling all my friends about your company. Read more

I bought replacement parts Read more

Replaced the complete door assembly. Read more

It works great and I finally have ICE and Thank You very much and it's the right part THANK YOU ???? I FINALLY HAVE ICE ?? Read more

Removed the back cover to access the fan area. Clean the area with brush and vac first. Unplugged the Refrigerator. Used a socket set with 1/4" socket. Had an extended and a standard socket. Removed the condensate plastic drain from the bottom of the refrigerator to have more access to the fan. Unplugged the fan motor. Removed the two screws holding the fan in place. Removed the fan unit from the condenser side of the bracket. Place new fan on the fan and installed exactly the way I removed the... Read more

After sliding out the old shelf I removed the middle track from the old shelf & installed it with the new left side track on the new shelf. They basically click in & out. Slid the new shelf assembly in & put meat drawer in place. Read more

I had no experience fixing a refrigerator, but I knew the problem was the door not closing. Suspecting that either the bottom hinge or the door gasket to be the problem, I decided to buy those parts from AppliancePartsPros to do the repair. First, loosening the bolts, I took the door out. Afterwards, I checked the bottom hinge and discovered that the hinge pin was worn out. The gasket for the door was not in a good shape (lost some magnetic adherence in some spots and had some holes), so I... Read more

I bought replacement parts Read more

Looked up the parts list and diagram by serial number. Found the correct part numbers and ordered 2 crisper drawers, the meat drawer and the bar that holds bottles on the bottom shelf of the door. The diagram showed endcaps needed on the bar, but that was only for if the bar was for the freezer door. Parts were a little expensive, but we're beautiful and delivered in just a few days. I have endcaps I don't need, but might need someday if any of them in the freezer we're to break. Overall, it... Read more

Looked up the parts list and diagram by serial number. Found the correct part numbers and ordered 2 crisper drawers, the meat drawer and the bar that holds bottles on the bottom shelf of the door. The diagram showed endcaps needed on the bar, but that was only for if the bar was for the freezer door. Parts were a little expensive, but we're beautiful and delivered in just a few days. I have endcaps I don't need, but might need someday if any of them in the freezer we're to break. Overall, it... Read more