796 4027 Parts

Kit is no longer available. Order MCJ61861201 and ACP72929002 separately.

Secures rubber hoses to fittings with constant spring tension to prevent leaks. Replace when rusted or weakened to maintain a tight seal. Confirm fit.

Factory cap screw secures panels, brackets, and internal assemblies in your washer. Replace if stripped, corroded, or missing to restore tight fit.

Fix PE error codes and water overfilling issues with this pressure switch. Monitors tub water level to control fill and drain cycles. 30-minute DIY repair.

If your microwave shuts off mid-cycle or won't heat, the thermostat may have failed. This safety control monitors temperature and protects components.

Fix washer leaks with this hose clamp. Secures hoses to pumps and valves, preventing water leaks and disconnections during wash cycles. Simple repair.

Replacement mounting bracket holder that secures internal washer components. Needed when your original bracket is cracked, broken, or missing.

Tapping screw secures washer panels, brackets, and trim in place. Replace stripped, rusted, or missing screws to restore proper fit and stability.

Fix exposed fasteners or openings on your washer dispenser with this protective cover cap. Keeps dirt and moisture out while restoring a clean finish.

This Leg Adjusting Wrench is a simple tool used to turn and secure appliance leveling legs so washers and dryers sit flat and operate quietly. It makes adjusting legs faster and helps reduce rocking and vibration. What it does:

• Fits over standard appliance leveling legs to raise or lower each corner
• Helps stabilize machines to prevent rocking and uneven operation
• Reduces vibration and noise caused by unlevel appliances
• Useful when installing, moving, or re-leveling washers and dryers

• Turn legs slowly and adjust one corner at a time until the appliance sits level.
• Unplug the appliance (and shut off gas supply for gas dryers) before performing major moves or checks.
• Use caution to avoid pinching fingers when lowering legs; keep hands clear of pinch points.
• Check for damaged feet or mounting hardware and replace as needed.

This noise filter assembly is an electronic component that suppresses electromagnetic interference generated by the washer's motor and control board. It is typically mounted near the power inlet and helps protect other household electronics from electrical noise. Replace this assembly if your washer fails to start, trips a breaker, or if the filter housing appears burned or damaged.

Does not come with a hose or filter. These have to be purchased separately

Fix excessive vibration and loud noises during spin cycles with this washer suspension assembly. Stabilizes the drum and reduces movement during operation.

Pivot hanger assembly that supports and stabilizes washer components. Replace if worn, damaged, or causing misalignment to restore smooth movement.

Joins your washer's water line to internal plumbing with a secure, leak-resistant connection. Replace this connector if cracked, worn, or leaking.

Secures internal components to the washer frame. Replace if your bracket is cracked, rusted, broken, or missing to restore stable support and alignment.