Bosch Hmv 8051 U Parts

I have a Jennair jjw9630cas double wall oven, and after a few years I noticed that the light would not go out, first in the bottom oven, and then in the top oven. After doing some research I discovered this was not uncommon, and the fix usually involved replacing the hinges and/or the hinge receptacles. It didn't look like a difficult fix so I ordered four new hinges and four new receptacles, which arrived quickly. I found a video on YouTube that showed how to replace the hinges and it... Read more

• Little to no heat when broiling
• Little to no heat when baking
• Won't start
• Gas igniter glows, but will not light

There are two igniters in oven, one for top broiler and one for bake oven at bottom. Your website help me troubleshoot the problem and locate the part. ordered part was delivered the next day. Following the instructions that others on your website had provided, the repair was quick and SUCCESSFUL. No need to pull out oven as power cord can be accessed from removing bottom storage drawer. Step 1: Remove the storage drawer from below the oven and disconnect the power cord from inside. No need... Read more

• Oven is too hot
• Won't start
• Little to no heat when baking

Spoke to a parts pro and told them of the problem. there were 2 possibilieies from the explanation of what the parts do. onw could have been the Range oven igniter. that wasn't it beaacause the over was lighting fine. by process of illimination it was the Oven Sensor Assembly. Read more

Since I have already made this same repair twice (once on my own appliance and once on a neighbor's), I'm getting pretty adept at it! Here are the steps: 1. Remove microwave oven door. 2. Using a putty knife, gently pry out the black plastic outer bezel. 3. Remove two visible screws near the latches that secure the inner prongy metal frame. 4. Using a putty knife and/or screw driver, lever up the metal frame by releasing the small tabs on one or two sides - (this is the trickiest part of the... Read more

Similar to other stories on here, the microwave was repeatedly tripping the circuit breaker, usually when opening the door. Plugged microwave into a different outlet/circuit, and problem traveled to that breaker, so definitely issue within the appliance. Turned out to be door interlock switch. This model has 3 switches: 2 x AP4512903 (00617228, the Primary and Secondary interlock switches) and 1 x AP4512904 (00617229, the Monitor switch). It was only the Monitor switch that was defective, but... Read more

One of the three-door switches had failed. In my case, 00631512 or ref 25217585 on the left front of the unit. The green button no longer "clicked". When that switch fails, one of the ceramic fuses located under the top cover at the far back of the unit is blown. Used Volt-Ohm meter to determine which fuse. Happy to have also ordered a replacement door switch Support, just in case, as I was unable to remove the failed switch from the support without breaking a key brittle plastic tab.... Read more

Similar to other stories on here, the microwave was repeatedly tripping the circuit breaker, usually when opening the door. Plugged microwave into a different outlet/circuit, and problem traveled to that breaker, so definitely issue within the appliance. Turned out to be door interlock switch. This model has 3 switches: 2 x AP4512903 (00617228, the Primary and Secondary interlock switches) and 1 x AP4512904 (00617229, the Monitor switch). It was only the Monitor switch that was defective, but... Read more

Similar to other stories on here, the microwave was repeatedly tripping the circuit breaker, usually when opening the door. Plugged microwave into a different outlet/circuit, and problem traveled to that breaker, so definitely issue within the appliance. Turned out to be door interlock switch. This model has 3 switches: 2 x AP4512903 (00617228, the Primary and Secondary interlock switches) and 1 x AP4512904 (00617229, the Monitor switch). It was only the Monitor switch that was defective, but... Read more

Ordered the charcoal filter Lowe's told me to order. It was the wrong one and arrived damaged anyway. The AppliancePartsPros person I talked to gave me a credit for the wrong filter and sent me the right filter. It arrived in one day, plus it was almost $30 cheaper than the one Lowe's told me I needed. I couldn't be more pleased with the service and prices at AppliancePartsPros. Thank you. Read more

• No heat

I believe the problem was caused by a power surge when our electricity returned from an outage. FirstI removed the two screws on top and removed the vent. This exposes the one screw that holds the control panel in place. First I checked the fuse to see if blown but it was ok. Two screws hold the plastic. bracket in place that holds the 3 door switches. Uncouple the wires attached to the switches and pull the bracket out. Then carefully pull the switches out of the housing with a small screw... Read more

I was getting really frustrated with our oven. It would preheat to the correct temperature, then slowly lose heat until it was down to about 200 degrees. So it took about two hours to heat a pizza! Finally decided to repair the oven myself, rather than pay $300.00 to have a repair person come out. Ordered the replacement igniter from AppliancePartsPros.com, and it arrived in two days. I followed the instructional video on the AppliancePartsPros.com website, and it was going well until I... Read more

Pretty easy repair. Removed two top screws, then used a credit card and flathead screw driver to slide out the old plastic tabs that had broken off the old part. Then, put in new charcoal filter and new part. Attach both top screws and do not over tighten.... done! Read more

It was very easy to replace. two screws held in top clips. clips had broken off Read more

After looking at many different stores for a replacement part, finally looked on GE website - the part was rediculous - then found AppliancePartsPros.com & saved $20.00 on the part! It took a considerable amount of time to locate the part but once I discovered APP.com, took seconds to order & seconds to replace - very pleased! Read more

Didn't have to -- you had a compatible product and sent it to us. Read more

So, you would think that Bosch would make the door handle a TAD more accessible for a quick replacement and repair. You have to first remove the plastic lining on the back of the door, then the black metal surround that holds the inner glass to be able to get to the two screws that hold the door handle supports. It takes some patience as most of these two peices and "snap" in and you just have to carefully see how the two components are held in to remove them without breaking them. So.... 1 -... Read more