Advantium Oven Parts

I replaced the parts with the help of a video provided by Appliance Parts Pros! There was enough detail that I was able to figure out what to do for my model of Advantium and the replacement went very well! It's like having a new appliance! Read more

Removed door from hinge best to use putty knife to push on clips to remove inner seal but broke clips anyway. Remove screws and pry clips to remove metal inner frame to access screws for handle. Read more

Watching some helpful do-it-yourself hints on Vidoes. Had to disasemble the door, because the screws for fastening the handle where hidden behind the inner part of the door. Videos did not show the step of unscrewing 6 tiny gold colored screws that held the door assembly together. Then used a screwdriver to pop off the plastic door cover with the window. The handle was easily and securely fastened into the plastic door cover. Just as a precaution, I disconnected the electric cord. ... Read more

My husband was able to take the door apart and install the handle once we received it. Read more

Suspected Magnetron failure so I ordered replacement. Unplugged unit and let it sit for a couple of days. Removed it from the wall/range top mounting Removed cover. Unplugged terminals to capacitor; one at a time; carefully kept leads away from each other There were (4) main screws holding the magnetron in position; removed those. Removed the thermal sensor that was attached to the magnetron housing Re-attached the thermal sensor to new magnetron housing Re-attached the new... Read more

14 year old GE Profile microwave wouldn't heat, but had power. Read reviews here. Ordered triumvirate of magnetron, capacitor, & diode. Was hoping not to need the capacitor as this was an expensive part; and if not needed to return to AppliancePartsPros, which has been SOP. After watching a couple YouTube videos of microwave capacitors being shorted, I made a capacitor discharge tool ordering 24W 100K Ohm resistor and high voltage test wires w/ alligator clips from amazon. At the same time,... Read more

Problem was the primary interlock switch. The switch checked OK for continuity but when installed and activated by the door closing, the switch would not close due to the over travel in the switch caused by the door lever. That would have been easy and inexpensive, however when attempting to disconnect RY2 while troubleshooting the top of the relay came out which was impossible to reassemble. That mistake cost me a new main board ($180). SO, if you disconnect the relay hold the top in place... Read more

Replaced the PBC Board and it works like a charm now. Shane with the chat line emailed the service manual which was a tremendous help. Read more