At19n8 Parts

Replaced the water tube that went from the plastic tubing to the ice cube tray. Found that even though it was the same exact length as the original, there was only an extremely small gap from the end of the tube to a splash board. This may have been the root cause of my problems. Read more

This trash compactor is in our vacation home. We never use it and now we are selling the house. When I looked to replace it I was amazed at how expensive a new compactor would cost. I found the serial number on the current compact entered it and your web site came up. Your schematics were excellent and made the repair very easy! Read more

Ordered new Evaporator part and Drier from Appliance Pros. The part arrived earlier than expected and was properly packaged. I had both parts installed by a professional as they required a level of expertise above my capabilities. Works perfectly. Read more

Replaced broken retainer and put the shelf back in place. Read more

At first, I suspected the evaporator fan motor was going bad, but when I went in to check it out, I found the evaporator coils totally frozen up; the fan was cavitating. I defrosted the coils completely and checked everything out. By process of elimination the Defrost timer had to be the culprit. I unplugged the timer and sure enough, the motor winding was open. Replacing the defrost timer fixed my problem. Troubleshooting (using the information available on your web site) took a little... Read more

Replaced the ice tray and motor mount plate. While I was there I replaced the thermostat also. New parts arrived in a day and a half. Read more

Checked out the video on your site on how to disassemble the ice maker. Was really easy when you know the correct sequence. Only 3 screws and it's out of the freezer. Disassembled the ice maker on my kitchen counter and replaced the ice stripper. Reassembled and installed back in my freezer. It is as good as new Read more

I had to cut one bar for the small door shelf since they only come in one size. The bars pop in on plastic clips. Read more

Replaced motor, fan and lock-nut. My repair was on a built in Refrigerator-Freezer so most of the time was spent on pulling out and putting back the unit to get to the area I needed to behind the upper top. Read more

I read the help guide on the AppliancePartsPros.com web site and then decided to test my defrost heater with a volt/ohm meter. I read an open circuit. I then removed the radiant heater element from the refrigerator and see nothing wrong with the element, but the connection on both sides to it, that resemble a spark plug wire to an automotive plug, was corroded to a powder making no electrical connection. I then searched for the replacement part to find that Amana discontinued the part after... Read more

It was a relatively easy fix and the video instructions on this site provided were helpful. The one piece that wasn't clear is the alumilastic was already on the replacement part so a separate tube is not required. That wasn't clear on the video and was an unneeded expense. Read more

Watched the video at Appliance Parts Pros. Followed the video. I was fixing the refrigerator door (a little easier then the freezer door). The repair was very simple and took less then 15 minutes. Read more

• Fridge too warm

Replaced the heater coil and the Thermostat underneath the freezer floor. 1. Unplug the Power, allow the ice build-up to thaw (Use hair-dryer). 2. Remove the heavy duty Plastic Tray (Freezer Floor) very carefully (the left and right side lips of the tray are snapped behind the sides of the freezer frame, un-snap the lips using flat spatula) . Gently pull out the Tray 3 Remove the plastic shroud (cold air diverter) at the back of freezer section (after removing the screw, tuck-up the shroud to... Read more

Replaced burners and cleaned Read more