Gne27jymfs Parts

• Fridge too cold
• Too warm
• Fridge runs too long
• Freezer too cold

I unplugged the fridge and took all the food and shelving out of the freezer and then proceeded to take off the bottom sliding drawer rack on both sides off (4 Phillips head screws). Then took off the light bulb cover and then the light bulb. Then the back wall that covers the coils and tubes that the refrigerant runs through ( 2 screws with hex head). After sliding out the back wall I could see that the entire coil area was frosted and iced up. I took a blow dryer and melted all of it over... Read more

It was after 11:00 at night a few nights ago, I couldn't sleep listening to the whining of the fan in the freezer, it was running and making noise sounding like waaoooww, waaaoww. It also sounded like grumbling of a garbage disposal. The refrigerator fan motor was so noisy it was keeping me up all night going on and off running really loud and about to fail. So I was desperate, and called AppliancePartsPros when I couldn't get to sleep near midnight because the fan was so noisy and Bud in... Read more

Ordered a new one. Read more

We replaced the main circuit board and the LED started to work and the condenser fan worked, but all we had were relay clicking sounds, but no cooling. The compressor had become so hot trying to work when the main circuit board was amiss, that it had popped the over temperature sensor on its side. As some one point out, if you remove the PTC+OLP assembly with the capacitor on it, and shake it, you will hear a rattle inside---and that is bad. We ordered a second round of parts from... Read more

Replaced the valve configuration. It was pretty easy. Read more

• Freezer section too warm

New cond fan & new evap fan & new defrost heater unit Read more

I ordered 2 new shelves to replace the broken ones and they came really fast! They are a perfect fit and match in my fridge! Read more

Unplug fridge, then disconnect wire harnessess. Removing by pushing up. Next I install the new mullion. Plug refrigerator back and it’s working Read more

• Fridge too warm

Replacement of the evaporator fan motor, fan blade, and grommets. The amount of disassembly to reach the part took most of the effort Read more

I am a home owner with no technical experience on doing refrigerator failures diagnostic/repair. So, I look for internet DIY type of help describing the symptoms. I found recommendations from Appliance Parts Pros going from the easy to the complex potential parts failures and decided to order the compressor start relay and the compressor overload. While waiting for the overnight delivery, came to my mind and decided to look to the freezer compartment and found frost all along the coils panel.... Read more

Replacement of the evaporator fan motor, fan blade, and grommets. The amount of disassembly to reach the part took most of the effort Read more

Condenser fan stopped on my big 2003 Monogram 4 foot wide ZIS480D Refrigerator. It is top mounted. The fridge had to be rolled out. 20 screws removed and the top sheet metal to get at the condenser. That was the only way to get at it. Works like new now. Read more

Replaced the two door switches. Read more

I 100 percent recommend Appliance Pros. This was by far the best experience I've ever had making a purchase on line or via the the phone. Read more

Bought new part Read more

I bought the bypass from appliance parts pros. Read more