Gsd6000 Parts

• Will not fill with water

Ordered a new flood switch and activation stem from Aplliance Parts Pros.com. Order was delivered in about 3 days. Installed new switch and stem in about 15 min. Removed front kicker panel with two screws, the switch was just inside the panel secured with two screws. remove the electrical connector, removed screws, replace the two new parts..put the screws back in place and ran the washer...no overflows. Read more

I bought spare part from AppliancePartsPros.com and followed the instructional video. It was easy and saved a few bucks. Read more

Thanks to appliancepartspros.com the dishwasher was able to be repaired quickly and under budget. I removed the motor pump assembly and replaced it. I was also able to change out the faulty flood switch and replace the seals to stop the leak. The appliance is once again good as new and ready to run a new load of dishes. Read more

I replaced a few key parts that I couldn't clean properly, and were not spinning well in the dishwasher. Afterwards, it worked like new, and the cleaning power returned. Read more

Unscrew the sides and pull the dishwasher out and simple remove the old door hinges and put the new one in. Read more

Ordered parts, waited for them to arrive Took door apart, installed new parts Put door back together shut door (it stayed shut) Washed dishes, opened door (it opened) Dishes were clean (no water on floor) ALL DONE AND IT WORKS Read more

I ordered the part from Appliance Parts Pros; it arrived in three working days. I turned off the power and shut off the water to the dish washer, took off the toe guard and unscrewed the appliance from the countertop. I hoped that I could pull the dish washer out from under the counter without disconnecting the water and wiring as I had seen done in the video. Luckily, I didn't have to disconnect them and with a little effort I was able to pull the dish washer out so I could work on it. ... Read more

The Piston and Nut assembly replaced Check Valve and Body and gasket replaced Read more

I found the manufacturers parts drawing and purchased the parts that were needed.The previous home owner had not only removed from he parts but he had also reversed the direction of the dish rack. The only way I was able to repair it was to figure out how it must function,the rest was easy. Read more

Replaced with complete GE Pump and motor assembly. Also installed these other items, ( Piston & nut assembly, Valve,check and vent pad) Read more

• Not drying dishes properly

Found a service manual that is close enough to my GE dishwasher. Service Manual for GE Dishwasher-EDW4000 was found on the following webpage. http://www.applianceaid.com/pdf/serv-man-EDW4000.pdf Gives enough information to test out the dishwasher. Read it, check out Factory Test Mode. GE should have given this out as a normal User Manual. The usual user manual lack anything to help troubleshoot a problem. Read more

This was very simple. Thgey just popped back into place asnd the cap screws in. Read more

Rinse aid was not dispensing properly. so replacing the dispenser fixed the problem. Very easy to do with the replacement part, although the repair video was not exactly accurate; it was actually easier. Remove the screws holding the door liner and lift it off, and the part is right in front of you. 6 screws off, remember what color wire goes where, reassemble, and you're done. Problem gone. As usual, Appliance Parts Pros is the absolute best source. Read more