Hbl870 Parts

Foam seal tape creates a tight seal between your cooktop and countertop to contain spills and provide heat isolation. Replace when adhesive weakens.

Cushioning spacer that prevents metal-on-metal contact in ranges and wall ovens. Replace if worn, cracked, or missing to reduce noise and wear.

This replacement screw secures appliance panels and components at their mounting points. Swap in a new screw to restore a tight, rattle-free fit when the original fastener is missing, stripped, or corroded.

• Fastens the designated panel, bracket, or component in place
• Replaces a missing, stripped, or rusted screw
• Helps address loose panels, gaps, rattling, or misalignment at the mounting point
• Maintains proper assembly integrity after service or vibration

• Disconnect power; shut off water supply if working near plumbing
• Match to the removed fastener and replace one at a time to preserve alignment
• Start threads by hand to avoid cross-threading; use the correct driver bit
• Tighten snugly and avoid overtightening, especially into plastic or thin sheet metal

Oven won't start or stop correctly? A faulty micro switch prevents proper sensing of linked mechanisms. This switch restores accurate control signals.

Factory fixing kit with mounting hardware to secure panels, brackets, or trim on your wall oven. Replaces worn, missing, or damaged fasteners for alignment.

Conditions incoming AC power and suppresses electrical interference to protect electronics. Replace if your microwave won't start or behaves erratically.

This is a protective cover that sits inside the microwave cavity over the waveguide opening where microwave energy enters the cooking chamber. It prevents food splatter and grease from getting into the waveguide and magnetron components. Replace this cover if it is burned, scorched, cracked, or if you notice arcing or sparking inside the microwave during operation.

Oven door won't latch or stays locked? This door latch secures your oven door during cooking and prevents accidental openings. Moderate DIY repair.

Restore oven visibility with this complete light assembly. Replace when bulb won't light, lens is cracked, or socket is damaged. Verify fit with your model.

Microwave not heating? A faulty magnetron is the most common cause. This tube generates the electromagnetic waves that heat food. Moderate DIY repair.

Front console cover that frames the control panel on your wall oven or microwave. Replace if cracked, discolored, or worn to restore a clean appearance.

Replacement glass panel for wall oven doors. Restores appearance when original glass is cracked, chipped, scratched, or broken. Direct fit part.

Replace your wall oven door latch if the door won't stay closed, the oven won't start, or cycles are interrupted. Restores proper door closure and locking.

This is a thermal fuse designed to protect the microwave's electrical circuit from overheating. It acts as a safety device that breaks the circuit if internal temperatures exceed safe limits. Replace this fuse if your microwave suddenly stops working or loses all power, as a blown thermal fuse is a common cause of a completely dead unit.

Replaces cracked, chipped, or fogged oven door inner glass. Restores clear viewing and proper heat retention. Confirm fit with your model number.

Incandescent oven light bulb restores interior illumination so you can monitor cooking without opening the door. Replace when dim or burned out.