Kecc502glb06 Parts

• Element will not heat

Replaced the Infinite Switch and that solved the problem. Did not need to replace the Surface Element Read more

• Element will not heat
• Won't start

Turned off power supply. Removed two screws (near the oven door) holding the ceramic top. Slid the top forward, disengaged the two power supply cables, and removed one ground wire. Removed range top, and put on a flat surface. Unclamped two power supply wires, one ground wire and one thermocouple wire from the element. Unscrewed the bracket from the element, and remove the element from the range top. Remove the two clamps from the old element, and put them on the new element at the same... Read more

• Element will not heat

Purchased a new Element surface and installed same... All Okay now... Read more

• Element will not heat

This cooktop has a dual element with an inner burner surrounded by an outer burner. The switch controls either the inner burner alone or both. The switch failed in that it would not operate the inner burner by itself, both burners would come on and only on high. On 8/14/2014 I replaced the failed dual element switch as follows: • Turned power off to cooktop. • Removed unit from cabinet. • Removed metal edging and glass top. • Removed screws holding switch panel access underside. • Removed old... Read more

After being told by a service repairman that it would cost me close to $200 to repair, I resolved to just not use the dispenser. After about a year, I had decided that I wanted to repair it and would look at the options myself. At the least, I could figure out which parts were needed to repair it and have them on hand for a service guy if I determined I could not do the job myself. The more I studied it, the more I felt confident that I could do it, and sure enough, when the part arrived - a... Read more

Trial and error only cooktop unit. Everything mounted into the counter and needed to pull unit out. I figured it was a control switch or the burner itself. Based on costs, I took the less expensive route and replaced the 2 known malfunctioning switches. All on-line videos said it was a 2-3 hour process to replace. I finished mine in less than 30 minutes. Turned breaker back on and it works like a charm. 30 years old and still going strong. Read more

We ordered four replacement knobs from you folks, and installed two of them, keeping the other two as spares. Read more

Remove unit, remove about 12 screw holding the top to the unit switch the tops reverse steps and done Read more

Ordered a new switch (4456027) from you. You seemed to have the best price and guaranteed that it was a OEM part -not everybody did. I had repaired Jenn Air cook tops before so I thought this was not a problem. Wrong. Mostly it was my own stupidity. I exchanged the wires from the old switch to the new one at a time but did write down where the original wires went. Flipped the breakers back on. Only one heater got hot. Searched the internet for several days for a wiring diagram. Nothing much.... Read more

Within 6 months of use of the switch on the large dual element of the left front unit, the switch came loose from the mounting plate and would not allow the switch operation. It took me over 10 years to decide to fix it. The new switch was totally redesigned and was attached to the mounting plate directly with the small screws instead of using the mounting plate pressed onto small plastic horns on the switch, which ultimately failed when the user likely used too much downward pressure on the... Read more