Kuds301vbl38 Parts

Replacement mounting screw for dishwashers. Secures internal components and panels. Order a new screw if yours is stripped, missing, or damaged.

This is a small plastic or rubber fitting that secures the power cord where it enters the dishwasher's junction box or base. It prevents the electrical wiring from being pulled, kinked, or damaged by absorbing tension on the cord. Replace this part if it is cracked or missing, which can leave wiring exposed and vulnerable to damage during installation or use.

Protective shield component for your dishwasher interior. Replaces cracked, broken, or missing shields. Installs to guard sensitive components.

Dishwasher lower door seal prevents water leaks at the door base. Replace if you notice dripping or moisture during wash cycles. Confirm fit with your model.

Dispenser won't latch or close? This detergent dispenser releases soap at the right time. Moderate DIY repair requiring inner door panel removal.

Fix leaks around the dishwasher motor or poor spray pressure with this impeller and seal kit. DIY-friendly repair takes about 2 hours with basic tools.

Dishwasher won't start, stops mid-cycle, or displays won't light? The control board directs all functions. Moderately challenging DIY repair.

This hose clamp secures dishwasher hoses to fittings and ports to maintain a tight, leak-resistant seal. Replacing a worn clamp helps prevent drips and loose connections that can cause water under the unit.

• Secures drain or circulation hose to the pump, sump, or other dishwasher fittings
• Helps maintain a watertight seal at hose connection points
• Can help resolve water dripping from a hose joint or a loose hose
• Replace if corroded, deformed, cracked, or no longer holds tension

• Disconnect power and turn off the water supply before servicing
• Place a towel or shallow pan to catch residual water when removing hoses
• Fully seat the hose on the fitting, position the clamp over the barb/connection, and secure firmly
• After reassembly, run a brief fill/drain and check all connections for leaks

Dishwasher won't start or lights flashing? The electronic control board manages cycles and timing. Moderate DIY repair restores full operation.

The lower wash arm support cap secures and stabilizes the lower spray arm while allowing it to rotate freely during wash cycles. Positioned at the center of the dishwasher floor beneath the lower dish rack, it requires replacement when the wash arm wobbles, doesn't rotate, or when dishes in the lower rack remain dirty.

Fix intermittent power issues or loose connections in your dishwasher. This wire connector restores secure electrical contact between components.

Fix a dishwasher motor that hums or won't start. This run capacitor provides the phase shift needed for smooth motor operation. DIY repair in 30-45 min.

Secures trim and panels in dishwasher assemblies. Replace if clip is broken, missing, or worn. Prevents loose parts and rattling during operation.

Fix a broken or missing dispenser lid that causes detergent spills or won't stay closed. This dishwasher dispenser cover restores proper function.

Secures knobs, trim, or linkages to shafts inside your dishwasher. Replace if broken, cracked, or missing to prevent components from loosening.

Restores visible feedback on your dishwasher control panel. Replace when burned out or non-functioning to see cycle status at a glance. Verify fit by model.