Le4127w2 Parts

• Marks left on clothes

Recommendations have fun and a bucket to prevent losing parts. First watch the videos, practice disassemble and reassemble the dryer drum. Make certain you have a good screw driver and spatula from kitchen (could not find my putty knife). Secondly, clean and inspect everything, make sure the motor bearing and belt pulleys are in good condition with little or no play. Third after you have confidently disassembled, vacuum cleaned, inspected all the worn parts, grease the motor and pulley,... Read more

After replacing thermal fuse once and having it fail a second time, I had to dig a little deeper to uncover the problem. I checked for blockage in the vent but everything was clear. I did, however, find that the drum had some up and down play in it. After closer inspection, I could see that the front drum seal was actually worn to the point that I could see a gap between the seal and the drum. I figured that the gap in the seal was letting air in and not letting sufficient air flow through the... Read more

• Will not tumble

I went on line and purchased all of the possible parts that could be worn out. I spent less than the service guy wanted to show up...The online videos were spot on. Two hours and it works like new! One of the best values on the Internet! Read more

• Marks left on clothes

Kenmore Dryer Model 41791042000. Replaced the Front Felt Guide Assembly (5303937139) Lower Front Felt Seal (5303283286) Rear Drum Bearing Kit (5303281153) and Dryer Drum Belt. (134503600) Having performed this same maintenance 5 years ago I was familiar with the process which is fairly straightforward. However, the video for the Front Felt Guide replacement seems to no longer be on the website. Also, the video for the Lower Front Felt Seal is wrong, showing the replacement of some felt seal... Read more

The agitator stopped functioning and there was a squeaking sound occurring in agitation mode. I found that if I cranked down on the agitator cap, screwing in as hard as I could, the agitator would work briefly, then the cap would loosen and agitator stop moving. I removed the agitator cap, along with which came the agitator stud cap and a rubber washer/seal which was jammed up into the underside of the cap. I lifted out the agitator from the drum and inspected it and the hub best I could.... Read more

The seal at the bottom of the tub had started to fail. On large loads water would leak so I ordered a new one rubber seal. Getting the trunnion off the transmission shaft was hard as it was calcified and corroded. I used a wire brush to get some of it off and then used a lot of WD-40. The bolt holding the trunnion plate on sheared off when I tried to remove it on one side and the other came out ok (the bolt hole through the trunnion is not threaded so it should slide out once the plate is off... Read more