Mah5500bbw Parts

I just wanted to put my experience here for all to see. I have a Maytag Neptune, MAH5500BWW, one of the original ones. I bought it back in 2002 and it has done many many loads of wash faithfully. So when the bearings started to get loud I thought it best to replace them, the seal kit and the belt. I did my research as best I could and decided to order the OEM parts from an appliance supplier. If you are replacing the bearings, watch on line videos prior to performing the job. It will... Read more

Ordered the part from AppliancePartsPros.com, it arrived in an undamaged box but when I opened it and took the inner panel out it was cracked and small piece was broken off. There was no packaging in the box, just the plastic panel loose in the box. I called and they replaced the part next day shipping at no additional cost to me - Thank You AppliancePartsPros.com, great customer service! The repair itself was extremely easy. removed the door from the washing machine, then removed the... Read more

Once we found the hidden 'Troubleshooting Guide' in the control panel, we were able to run a diagnostic check on it. A voltmeter was VERY helpful, and after running through the steps, found that the "inertial unbalance switch" was bad. It was easy to get to by removing the door, front panel, and then lifting the top off...it is attached to the top of the tub. One screw needed removed from the switch, and then I slid the old one off and the new on! *I must say, it took longer to figure out... Read more

Basically rebuilt the washer from the ground up. Spent more money than a new washer but we have been so happy with the way this machine has worked over the last 19 years figured it would be money well spent. Read more

Initially replaced the pump. However, I believe the pump went bad due to the pressure switch failing and allowing the pump to run continuously. Once I replaced the pressure switch everything was fine. FYI, the wiring harness on my washer was slightly different and would not align to t the tabs on the new switch. I had to remove the black harness guide on top of the switch and just align the harness wires to the tabs manually. My ground wire was separate from the harness. I just plugged it... Read more

Opened the washer (details later) and noted the controls and water path. Ordered dispenser bottom and cover and dispenser valve assembly and rubber washers. When the parts arrived I removed the top portion of the detergent dispenser assembly; removed the door and 2 screws from opposite door wall; snap open the front cover and lifted it off; removed 1 metal screw each from the bottom front corners of the top cover; lifted the top cover and used a piece of wood to hold it up; pull... Read more

Drain pump motor burned up, melting the electrical connector. Got a wiring harness from eBay and cut/spliced connector. Got pump from these guys and installed it. Then got "FL" error (door failed to lock). Got chassis wiring info to meter wiring harness through lock solenoid from these guys, and it checked good. Asked them to validate my troubleshooting steps, which they did. Ordered and installed the circuit board and everything works fine. Replacing the pump was about 30 minutes and... Read more

I was able to find the parts and when they arrived, the replacement took just a few minutes. Read more

New felt, back and front. DID NOT NEED THE HIGH TEMP ADHESIVE for this model. Cleaned inside thoroughly. Read more