Msd2273evb00 Parts

Touch up paint Read more

We got a new part from AppliancePartsPros.com. Read more

• Not dispensing water
• Ice maker not making ice
• Leaking

A piece of cake. Video was spot on. Finish less than 45 min. Read more

Replaced It With New One Read more

Replaced filter cap with new one. The minor challenge was to find a method of pulling the filter out of refrigerator (which is normally done by pulling on the filler cap. The filter was recessed to far into the refrigerator for me to be able attach the new cap. I had to find another tactic to remove the filter. The solution was to look at the replacement filter to notice where two slots were located at the end of the filter. I then used a paint can opener (found at most paint stores) to slip... Read more

It was not hard at all to replace our refrigerator door gasket. First I found appliancepartspros.com because I was looking up on YouTube how to do the replacement. Your video was excellent and showed me that I indeed could perform the job. I had a question about the replacement door gasket and emailed your service team at the end of the day. By next morning you had replied with the actual part number for the gasket. Shipping was fast. I had watched the video several times and so performed... Read more

• Won't start

Tried to put refrigerator in defrost mode and defrost would not initiate. Checked the bi-metal and heater, both tested good. Replaced the ADC board and refrigerator went in to defrost. problem solved. Read more

I noticed Ice maker Quit for the third time in 15 years so I decided to buy another Ice maker, I installed it and NO ice still?? Well I went after the other problem thinking if it does not get cold enough maybe ice maker won’t work. I ordered Defrost Switch, Heater and Evaporator Fan just to be safe. I replaced all three, the fan was noisy, the heater OHM’d ok but I replaced it as did the defrost switch, I put it back together, the Freezer got to 0 degrees and the frig got to 38 degrees so I... Read more

With the help of the fantastic videos provided on the web site for each replacement part, it was extremely easy to complete the repair Read more

• Leaking

The drain pan (Tray-Evaporator Pan) was cracked in 2 places. We had to remove the front panel. Loosen the bracket that holds the water filter. Take off the back panel and disconnect the bracket that holds the selenoid. It was not necessary to unhook the water lines, just the bracket. It was not easy to remove the old pan and get the new one in, but holding the water filter, with the bracket intact, as far to the left side of the refrigerator as possible gave us the room to get the pan in. ... Read more

This was actually one of the easiest fixes I’ve done. All that was required was to remove 3 screws to remove the broken part. I used a pair of pliers to remove the moisture sensors from the broken part to the new one. Read more

Removed the worn gasket, cleaned the door, snapped on the new gasket. Read more

Replaced water reservoir that had become contaminated with ??? Also had to replace the water filter, because the water contaminated it also. Cost was about $150, for two filters and the reservoir. The first filter was replaced because I did not know the reservoir was contaminated, and no water was coming out of the dispenser. Since the water in the ice maker did not come through the reservoir, there was no smell or contamination there. The new filter enabled water to come through the dispenser,... Read more

Found the parts in the diagram of my fridge and simply installed it very easy Read more

Replaced icemaker and shutoff arm. Easy project. Read more

Replacing the cold control solved the problem. While i was at it i also replaced the defrost timer and installed a new ice door. Read more