Mtw5870two Parts

It was fairly simple, unbolted the agitator and pulled the old one out then put in the new...although when when a load became unbalanced the rocking motion slowly strips the bolt, I would suggest if replacing this unit also order the bolt. I also bought loctite dew to the fact that the bolt was stripped. Read more

Replaced flow meter and control valve Read more

In the end, with a new coupler. But I relearned old lessons the hard way. The washer is in a rental unit and the tenant complained of no spin. My first intuition was that the coupler failed again because I bought a cheaper one elsewhere a couple of years ago and not the brand name available here at AppliancePartsPros. But we’ll come back to that. Lesson #1: Verify the symptoms firsthand. I dug in right away, popped out the motor and the coupler appeared okay. When I spun it by hand, it turned... Read more

Replaced 2 springs and brackets. Also replace rear legs and front legs and re leveled. Works fine. Read more

Based on recommendation to replace the clutch if clothes aren't spinning dry enough, I ordered a new clutch. Upon disassembly, I observed no Ring Wire/C-Clip and that the bearing appeared worn. Where did the clip go? Well, the bearing wore down such that it wore out the clip and bearing up to the sleeve of the shaft. Knocked out the old bearing, tapped in the new and was done. I disassembled the brake shoes but believe you can get the bearing in and out without doing so. Not a bad job, just... Read more

I looked inside and saw the teeth were worn off the "dogs" so I purchased the Cam Agitator repair kit and a new bolt. Getting the old bolt out was the hardest part since it was worn and rusted. I ended up having to buy a set of socket extensions and a set of stripped bolt sockets so $45 in tools and it took me an hour to get the old bolt out but putting everything back together was a breeze. I was very proud of myself, as a woman, that I fixed this problem myself and didnt have to pay a repair... Read more

Purchased parts from your site and did a self repair. Excellent quality , speedy delivery and easy to install. Now our 13 year old washer works as good as new. Read more

Replaced dog ears. Read more

Ordered a new timer from Appliance Pros.com Read more

Replaced the agittator Read more

I replaced the thrust washer , agitator and agitator dog assembly. The repair took about 10 mins after watching the repair video. All works fine. Mike C Read more

Bought a new cord and removed the back of the washer and unclipped the old and clipped in the new. 5 minutes tops. Read more

This was the second attempt at fixing this problem. The first repair and parts were generated by listing the problem and reviewing the potential corrections, listed on the web site. From making repairs on other clothes washers, I was confident that some of those potential causes could have been the cause. Unfortunately the counterbalance spring and suspension springs were not the cause as they were attached as intended and in good condition. I reached out for Appliance Parts Pros input... Read more

A former repair man deleted the grommets from the motor mount plate, the spring fastening the motor to the bracket broke the screw inside the motor and once the motor fell out of place the drive to the the transmission was broken. Read more