Need Help?
Call
Some parts shown may not be for your model. To see parts for your model only, select it from "Matching Model Numbers" list on the left.
Replaces broken or cracked refrigerator door stop. Installs on door to limit swing range and prevent cabinet damage. Needed when missing or worn.
Replaced upper and lower thimble's, lever arm, cam closure. Door stop was not the problem, but ordered it and replaced it too. The door of course has to come off, remove the top hinge, and lift it away. Lubricated moving parts with silicone spray. Be sure and put the door back in the open position, so the lever arm and cam closure can properly interact, then close the door. Remove the plastic grate at the bottom to get at the lever arm. Presto. Problem gone. Don't put excessive weight... Read more
Replaces the damaged or missing edge trim on your freezer shelf. Snaps onto the shelf frame to provide a finished lip and restore its original appearance.
Replaced with new parts. Read more
This armature kit is the moving plunger and linkage operated by the dispenser solenoid. It opens and closes the ice chute door during dispensing and helps it seal when idle to reduce frost and warm-air leaks.
Replaced the water supply valve...boom! Read more
Protects the freezer light bulb from damage while maintaining visibility. Replace if cracked, yellowed, or broken. Confirm fit with your model number.
Replace solenoid, flapper door and recess spring. Really only needed solenoid, but other parts were so inexpensive and I knew I would already be in there. Read more
Carries defrost water from evaporator to drain pan in your refrigerator. Replace if cracked, brittle, clogged, or missing to prevent leaks and puddles.
Replaced the drain pan below the evaporator coil (it was rusted to the point had a hole in it) and decided to replace both drain tubes since I had to open up the back panel. The video on the website was very helpful. Thanks!! Read more
Supplies electrical power from wall outlet to refrigerator. Replace this cord if cut, frayed, overheated, or damaged to restore safe electrical connection.
Spliced new and old power cord near the connections in the fridge and connected them. Didn't mess with the factory harnesses or connections inside actual fridge. Read more
Straight 1/4-inch coupler joins two sections of refrigerator water tubing. Replace when cracked, leaking, or missing to restore connections.
Replaced hoses. They were not an exact replacement but they did end up working with the purchase of one additional fitting (5/16 x 1/4 coupler) Read more
Replace missing or stripped #8-18 x 5/8-inch Torx T20 screws in your side-by-side refrigerator. Secures panels, brackets, drawer rails, and trim.
Went online and looked for a parts dealer using the refrigerator model number. Read more
Fix a light that won't turn on or flickers in your refrigerator. This E12 socket replacement is straightforward with our step-by-step video guide.
When diagnosing the problem, I discovered that the ice door was not properly sealing and that the solenoid had appeared to rust/corrode forcing the door open. I replaced most of the ice dispenser internals (solenoid, crank, door, and spring) following the video. The door will now open when dispensing ice (which it does!), and will oddly stay open for a few seconds once I am finished, but does seal properly and the chute/container no longer frosts over. Read more
This articulating mullion assembly replaces the center mullion on compatible French-door refrigerators to restore proper door alignment and sealing. It helps the doors close evenly and reduces air leaks that can raise energy use and spoilage. What it does:
Refrigerator not cooling or running constantly? This compressor powers your cooling system. Advanced repair, allow 2-4 hours for replacement.
Replacement chill pan drawer that slides into refrigerator shelf rails. Needed when original pan is cracked, broken, melted, or missing. Exact fit.
Rolled it in!!. Read more
White rear motor cover for refrigerator. Shields motor and fan area at back of compartment. Replace if cracked, broken, or missing to protect components.
Pictures on website were great. I ordered the part needed. Very easy to replace. Read more
Fix a warm Custom Cool drawer or knocking noise from the bottom compartment. This fan assembly restores proper airflow for faster chilling. DIY repair.
I replaced the fan and heater element. The replacement was not an exact match. I had to adjust the parts to get the harness to fit the plug was not the correct size. I cut it off and used the existing plug. Not a big deal and everything else fit. Pretty good for a twenty year old replacement. Also the heater element was a different shape but it fit as is. Read more
Replacement mounting screw for refrigerator panels, brackets, door handles, and trim. Needed when original hardware is missing, stripped, or corroded.
Mounting screw fastens panels, brackets, and trim in refrigerators, dishwashers, and ranges. Replace missing, stripped, or rusty screws to secure parts.
New parts. Read more
By continuing to use our site, you agree to our Terms of Usage and Privacy Policy. You can learn more about how we use cookies by reviewing our Privacy Policy.
We use cookies to optimize website functionality, analyze the performance, and provide personalized experience to you. Use the controls below to manage your privacy preferences.
Cross-Site Advertising
When enabled, we may use cookies and similar technologies to deliver personalized advertisements based on your browsing activity across different websites. Opting out will disable third-party advertising cookies on this site.
Analytics Sharing
When enabled, we may share anonymized browsing and usage data with third-party analytics providers to help us understand how visitors use our site. Opting out will prevent this data from being shared with third parties.