Wrl767saim00 Parts

Remove and replaced the auger motor, shaft seal, and the chute seal. No problem. However, the causing failure was to broken wire on the bottom of the freezer door. Loom and blue wire were cut, due to being pinched. I had current to start with and the auger worked three times then quit. That's when I really had to start searching . Fun. Read more

Replaced all the parts ordered and adjusted door. Took about one hour to complete. Read more

The replacement drawer came with a crack - manufacturing defect. I called the vendor and got replacement at my door NEXT DAY! No red tape at all! Read more

Bought new optic control boards, both the emitter and the receiver. The repair process was so simple. The KitchenAid repair tech came out to diagnose our issue. He was only going to come back and install a new emitter. They wanted a lot of money to do the repair. They were going to charge us $257 just for the part (emitter board). We bought both boards for $300 from AppliancePartsPros. We decided to replace both boards, because if one went bad the other might not be far behind. Read more

Easy fix. Ordered a new defrost thermostat. Watched video. Installed a new one. 10 min. DONE. Read more

Ordered replacement light module Read more

I ordered the parts from you guys and printed the diagrams you had available. With that the repairs took less than 30 minutes. Read more

Replace front & rear wheels. Read more

Replaced the auger motor. Read more

I put all pieces that I ordered on the dryer and plugged it in. Read more

Replaced hoses. They were not an exact replacement but they did end up working with the purchase of one additional fitting (5/16 x 1/4 coupler) Read more

I purchased replacement parts to completely replace basket, face plate, and rollers. I received exactly what I ordered. The only problem I had was removing the part(s) from the shipping box. I thought the part came assembled (as rollers had been installed onto the basket), but the face plate had not been snapped into place. When I removed everything from the shipping box as one piece, the face plate fell off, hit the tile floor, and cracked. Bummer. Since the original face plate was in good... Read more

Removed the handle with two screws on the inside front and pulled out the custom wood panel. Pulled the compactor out from under cabinet. Tipped it over on back of unit, supporting it with a little foot stool. Unscrewed two lower screws at bottom of unit holding black trim panel (that held wood panel in place) and lower black rubber flap. Removed two screws on lower outside side of unit that held the foot pedal. Slid off black U shaped metal frame from top of compactor towards bottom. Slid on... Read more

Replaced the tube. The original part number could not be found. This tube that we ordered had an curved connector at the bottom and a hard connector on top. The original tube had a right angle connector on the bottom and a smaller connector on the the top. The curve on the bottom worked. We had to cut the top connector off the tube for it to fit. We then secured it with the original metal bracket at the top. No leaks! All working fine now. Read more

Rather than fighting the set screw, I ordered a new handle and extra parts to fix it. My father taught me to use anti seize which I used on all the threaded materials. Appliance parts and all the parts listed easy to see and Order Read more