Grinder Blade Parts

• Ice maker not making ice
• Ice maker won't dispense ice

Replaced both parts Read more

When we inspected the first time we found that Plactic had broken from the spiral part that for wards the ice. Also there were cracks in two places of other parts. There was a hole in the bottom of the bin. The new spiral was assembled and two new parts were replaced with help from the video and the diagram and the unit worked well. Two months later, ice maker would not forward any ice though the bin was full. We emptied the bin sand have ordered a new part or two in hopes that they will... Read more

Purchased Appliance Parts Pros replacement ice maker, removed the defective unit, matched the proper wiring harness using the wiring color codes at the P and J side connectors. Approximately 1 hour following the installation, I delightfully heard the first set of cubes ! Read more

I ordered a new bucket and auger combination--I didn't want to have to completely disassemble the mechanism to replace the rusted auger helix dispenser, so for about twice the cost of the auger alone I got the complete assembly. The product arrived in pristine condition less than 48 hours after I purchased it online. About 10 minutes later (most of that spent taking out the old bucket and finding my philips head screwdriver), I had removed the four screws holding the cover plate on the old... Read more

Filter replacement is easy. CAUTION. When removing the wand that is immediately above this filter you must reach around the back base and feel for a tab sticking out. Pull on it and lift the wand up. If not you may break the tab off which is a retainer needed for the center wand that supplies water to the upper rack. This would have been a 15 minute job but I broke the tab off I mentioned earlier. I ended up adding a stainless steel screw through the base just above a flange that rises when the... Read more

Replaced the top bearing assembly, drive belt, and blower wheel. The most time consuming and difficult part was putting the new drive belt back on the pulley and tensioner. Be sure to know how it is routed through them. It is a very tight fit getting your arm in there and connecting it blindly. Read more

Replaced ice maker. Read more

I found a video/tutorial on how to take it apart to see what was pieces were broken, then ordered the replacement parts and watched the video to put it back together again. Read more

My problem started with a rusting condition in the ice bin that spiraled out of hand. I took apart the ice bin and all the hardware thinking I could clean it with the suggested baking powder. Plastic parts cleaned up like new, metal parts were pitted. I wire brushed and sanded the parts put it all back together and gave it a try. All appeared fine then two days later the ice dispenser stopped. I watched a couple of videos and most pointed to the ice auger motor. One video specifically said you... Read more

I ordered part from appliance parts and it was perfect fit. Read more

Evaporator fan was loud and eventually quit. This allowed the freezer temp to rise above 18 deg. which they activated the PF code. Replacing the evaporator fan motor fixed the problems. Read more

Ordered a replacement valve and installed it. The part from AppliancePartsPro was an exact replacement for the original part. Replaced the hot and cold hoses at the same time to insure no leaks. Cold water settings now work properly again. Read more