Need Help?
Call or text
Fixes ice buildup in freezer and reduced cooling. This bi-metal defrost thermostat monitors evaporator temperature. DIY-friendly repair, about 20 minutes.
Changed out the Bimeti - Def, or defrost thermostat. Super easy repair, took about 20 minutes total. So far it seems to have fixed it. Fingers crossed! Read more
Dryer won't start or overheats? A faulty high-limit thermostat breaks the heating circuit to prevent damage. Easy 5-10 minute DIY replacement fix.
Replaced the themal fuse Read more
Freezer cold but fridge warm? Excessive frost buildup? Your defrost thermostat may have failed. This sensor controls the defrost cycle timing. Easy DIY fix.
The Thermistor is an OEM Replacement Part that maintains the temperature inside your Frigidaire refrigerator. This thermistor handles reading the internal temperature. After reading, it transmits this information to the control system. At a temperature of 29 degrees, the thermistor should exhibit a resistance of about 35k ohms. While at room temperature, it should read approximately 5k ohms.
Causes of a bad thermistor can include regular wear and tear, exposure to moisture, or electrical issues. Over time, the thermistor may become less accurate or stop working altogether.
Symptoms of a bad thermistor include:
This OEM replacement is also compatible with Electrolux, Gibson, Kelvinator, and Kenmore models.
Hired a retired local appliance repairman who was recommended to me to replace parts. The unit is now working okay. Read more
Fix ice buildup in freezer and warm fridge temps. This defrost thermostat monitors evaporator temperature to control defrost cycles. DIY-friendly repair.
After watching numerous videos I was able to discern that the problem was with one of the following: the timer, the heater, or the thermostat. a short time check showed me that the timer was working so that narrowed it down to the other two. Not having the necessary tools to check those two I ordered both parts. Once the parts came and I took out the old parts it was quite evident that it was the heater since it had black burn marks on it. I decided to install the thermostat also since it... Read more
This heater harness installs in the refrigerator's fresh food section. It provides defrost heat and the correct wiring connections to clear frost from the fresh food evaporator, restoring airflow so the compartment cools evenly and reliably.
Dryer not heating or running too hot? This high-limit thermostat regulates temperature to prevent overheating. Easy DIY fix takes 30 minutes or less.
FIRST I PULL THE DRYER OUT FROM THE WALL AND TOOK THE BACK OFF. WITH A 5/16 NUT DRIVER. NEXT WITH A LIGHT SET UP I LOOKED FOR ANY BURNT, BROKEN,OR LOSE WIRES THAT MY HAVE COME OFF ANY CONNECTIONS. I HAVE AN ELECTRIC DRYER AND AS I LOOKED DOWN TO THE HEATING COIL AREA, WHAT I WILL CALL A HI-TEMP SWITCH I COULD SEE THAT THE PART APPEARED BURNT. I PULLED THE POWER PLUG AND TOOK MY VOLT, OHM, MIL'LI'AMP METER, SET IT TO OHMS ON ABOUT 20K. THEN I TOOK MY NEEDLE NOSE PLIERS AND PULLED ONE WIRE... Read more
Fix F4 error codes or sensor cook failures with this microwave humidity sensor. Restores automatic cooking cycles. Moderate DIY difficulty.
Replaced the Humidity sensor, Thermistor and door switches. I replaced these thinking the problem was one of the items but didn't want to trial and error one part at a time. Plus the cost was reasonable so if these didn't help I wasn't out a lot of money. I sense the door switch was the problem. Replaced all items and the microwave works great. Thanks for the advice and the cost of the parts. Read more
Fixes dryer not heating or overheating issues. This safety thermostat monitors temperature and cuts power when too hot. Basic DIY repair, 30 minutes.
With a screwdriver and some mechanical aptitude. Nothing harder that a few screws to change the parts. Read more
Dryer won't heat or start? A failed thermostat breaks the heating circuit. Common DIY fix—test for continuity with a multimeter. Typical repair time: 30-60 minutes.
Changed Thermistor, Thermostats and the Thermal Fuse Assembly. I did not remove drum, so squeezing my hands in-between drum and vent hose pipe to remove screws was a tight fit, but doable. Read more
Dryer overheating or taking too long to dry? This control thermostat regulates internal temperature by cycling the heater on and off. Easy replacement.
I replaced both thermostats, the seals and the heating element and the belt. It's an easy job to keep my dryer last longer. Read more
Fixes long dry times and temperature issues. This dryer thermostat regulates heat cycling to prevent overheating or underheating. Simple repair.
Dryer not heating or overheating? This high-limit thermostat cuts power when temperatures exceed safe levels. Common fix for no heat issues.
Replaced the thermostat and working fine now. Read more
This replacement moisture sensor bar mounts inside the drum and helps the dryer detect when laundry is dry. A worn or damaged bar can cause sensor-dry cycles to end too soon or run too long.
Dryer overheating or shutting down unexpectedly? The high-limit thermostat monitors temperature and cuts power to prevent damage. DIY repair in 30 minutes.
REPLACED BELT AND IDLER. TESTED AND FOUND THERMAL LIMITER BLOWN SO REPLACED IT. DRYER WORKS GOOD Read more
Fix a dryer that won't heat, overheats, or runs too long. This thermostat cycles the heating element to maintain safe drying temperatures.