Tank Ce Small Engine Start Switch Parts
Genuine Whirlpool part
By: Whirlpool
Part Number: WP8268909
Dishwasher overflowing or not filling properly? The water level switch controls fill amount. DIY-friendly repair, typically 20 minutes with video guide.
Do-It-Yourself Stories from Customers like You
Washer would not fill with water Ty J. • Hillsboro , OR • July 08, 2018
Replaced float switch and also replaced intake valve. Worked like a charm and the process was as easy as the YouTube video I followed made it seem.
Read more
More
$50.57
- Compare At:
-
$59.67
- You Save:
-
$9.10
Genuine Whirlpool part
By: Whirlpool
Part Number: WP8286070
If your triple burner stays on high or won't adjust temperature, this infinite switch restores precise heat control for small, medium, and large rings.
Do-It-Yourself Stories from Customers like You
Lower front left burner would not shut off this burner is the single dual and triple element burner Maurice B. • San Diego , CA • May 07, 2015
Replace switch
Read more
More
$109.41
- Compare At:
-
$131.29
- You Save:
-
$21.88
Genuine Frigidaire part
By: Frigidaire
Part Number: 318394803
Has three terminals.
Do-It-Yourself Stories from Customers like You
Oven light stayed on when door was closed Robert S. • Jacksonville , IL • June 14, 2015
When trouble shooting the problem I found that the light switch housing outer lip was broken allowing the switch to push through mounting surface behind the oven door. This is a slide in range so, I proceeded to pull the range away from the counter where I could unplug the power cord. Once the power was off like located the panel on the right upper side of the unit and removed the screws to allow access to the switch. I then unplugged the switch from the wiring harness and removed the damaged...
Read more
More
$53.95
- Compare At:
-
$63.66
- You Save:
-
$9.71
Genuine Frigidaire part
By: Frigidaire
Part Number: 903097-9040
Element won't heat or overheats? This infinite switch kit restores precise temperature control to your cooktop's burners. Fixes erratic heating issues.
More
$78.95
- Compare At:
-
$93.16
- You Save:
-
$14.21
Genuine Whirlpool part
By: Whirlpool
Part Number: 9871829
Fix a compactor that won't start, stops mid-cycle, or requires holding the pedal down. This drawer tilt switch is a quick 15-second replacement.
Do-It-Yourself Stories from Customers like You
Compactor would start sometimes by just closing the door when you start it by normally lifting the pedal it would not stop at the end of it's cycle Bruce H. • Hewitt , NJ • January 19, 2015
I replaced the upper switch that contacts the door in a closed position and more important the start switch contacted by lifting the start pedal.
Read more
More
$50.57
- Compare At:
-
$60.18
- You Save:
-
$9.61
Genuine Lg part
By: Lg
Part Number: EBF60662911
This is a spark ignition switch assembly with wiring harness that controls the electric igniters on a gas range cooktop. It sends voltage to the spark modules when a burner knob is turned, initiating the clicking ignition sequence. Replace this part if your burners won't spark when turned on, spark continuously even when knobs are in the off position, or if only some burners ignite properly.
This part fixes the following symptoms
-
Doesn't shut off
-
Gas igniter glows, but will not light
See more...
Do-It-Yourself Stories from Customers like You
All the igniters spontaneously began to fire Michael S. • Adams , NY • October 12, 2019
Found a YouTube video online that provided instruction on how to change out the part.
Read more
More
$74.95
- Compare At:
-
$89.19
- You Save:
-
$14.24
Genuine Whirlpool part
By: Whirlpool
Part Number: W11206737
Fix a range hood control knob that stops responding or only works in one position. This rotary switch restores precise fan and light selection.
More
$19.95
- Compare At:
-
$23.74
- You Save:
-
$3.79
Genuine Whirlpool part
By: Whirlpool
Part Number: WP12575501
This limit switch monitors a set condition and opens or closes its contacts when that limit is reached. Replacing a failed switch restores proper safety cutoff and consistent operation of the appliance's heating or movement system. What it does:
- Senses a limit condition at its mounting point (such as temperature or travel/position, depending on model)
- Changes state at a defined threshold to protect components and wiring
- Interrupts power to heat or motor circuits, or signals a control to respond
- Common failure signs: no heat or shuts down early, runs continuously, won't start, or intermittent operation
What's included:
Install notes:
- Disconnect power to the appliance before servicing
- Note wire positions; transfer connectors one at a time or take a photo for reference
- Reinstall in the original orientation so the actuator or sensing surface contacts the correct area
- Address root causes (blocked airflow, binding mechanisms, shorted components) to prevent repeat failures
Do-It-Yourself Stories from Customers like You
Water dispenser quit working Frank K. • Pass Christian , MS • February 20, 2017
I replaced the switch which was bad and also replaced the water inlet valve.
Read more
More
$49.51
- Compare At:
-
$59.41
- You Save:
-
$9.90
Genuine Whirlpool part
By: Whirlpool
Part Number: WP22001656
This is the washer's water level switch that senses tub level via air pressure and provides five selectable fill settings. Replacing a failed switch restores accurate filling and lets the cycle advance properly through wash, rinse, and spin.
- Monitors air pressure from the tub to detect actual water level
- Controls the inlet valves to start/stop filling at the selected setting
- Signals the timer/control to begin agitation and advance the cycle once full
- Common symptoms: overfilling or water keeps running, stops filling too soon or won't fill, inconsistent water levels, cycle won't advance due to incorrect level detection
What's included: 1 water level pressure switch with 5-position rotary selector Install notes:
- Disconnect power and turn off water supply before servicing
- Access the control console; remove the selector knob/dial and panel as needed
- Note wire locations (take a photo), move the harness, and transfer the pressure hose; ensure the hose is clear and firmly seated
- Securely mount the new switch, reassemble the console/knob, restore utilities, and test each fill level
Do-It-Yourself Stories from Customers like You
Water level in Maytag washer was always high and was not adjustable Von D. • San Bernardino , CA • December 21, 2017
Replaced the water level switch and water level pressure switch hose. Video on AppliancePartsPros.com detailed the procedure.
Read more
More
$127.65
- Compare At:
-
$151.90
- You Save:
-
$24.25
Genuine Whirlpool part
By: Whirlpool
Part Number: WP9763761
If your range burner won't heat, cycles incorrectly, or buzzes when turned on, a faulty infinite switch is likely the cause. Moderately easy DIY repair.
Do-It-Yourself Stories from Customers like You
Stems were broken on handles. Knobs didn't work correctly. Dan R. • Glendale , CA • May 06, 2020
Had to replace both switches. The hard part was getting the control panel off to get access. Only a few screws but even after getting them out, really struggled getting it off. After getting off, discovered that you need to get it lifted up before pulling it off.
Read more
More
$142.95
- Compare At:
-
$168.68
- You Save:
-
$25.73
Genuine Whirlpool part
By: Whirlpool
Part Number: WPW10274880
Fix a dishwasher that stops mid-cycle with a blinking start light. This door interlock switch restores reliable operation. 20-minute DIY repair.
Do-It-Yourself Stories from Customers like You
Kenmore ultra wash dishwasher worked great for 18 months; then would not run start button blinked 3 times and nothing happened Nick C. • Safety Harbor , FL • November 12, 2015
Looked online, appeared to be door switch or control panel. Tried door switch first, a $30 part. Installed new door switch and washer started right up and appears to be fixed. Have not tried full wash cycle yet, but problem appears to be fixed. I decided to buy part from AppliancePartsPros.com because I could return the part if it did not correct the problem, no one else offered such a deal. I will only deal with AppliancePartsPros in the future, they were extremely helpful on the phone!
Read more
More
$50.57
- Compare At:
-
$60.18
- You Save:
-
$9.61
Genuine Ge part
By: Ge
Part Number: WR08X10112
Fix compressor clicking every few minutes or fridge not cooling. This start relay and overload combo helps your compressor start and prevents overheating. Easy 5-minute fix.
Do-It-Yourself Stories from Customers like You
Constant clicking sound from behind refrigerator and compressor would not kick on all the time freezer temp was above the desired temperature Peter H. • Bayside , NY • May 10, 2016
I replaced the old capacitor and combo device after watching repair video. Took less than 5 minutes and now my ge profile refrigerator is running perfectly.
Read more
More
$108.30
- Compare At:
-
$128.88
- You Save:
-
$20.58
Genuine Frigidaire part
By: Frigidaire
Part Number: 5304511344
The Switch is an OEM component specifically designed for Frigidaire washing machines. It controls various cycle options like water temperature levels, spin speeds, and additional settings like stain removal cycles.
Causes of a bad switch can include water or chemical damage leading to component failure over time, or loose wiring connections causing intermittent issues.
Symptoms of a bad switch include:
- Inability to select wash cycles or adjust settings
- Unresponsive or inaccurate temperature levels
- Lights/displays not functioning as normal
- Error codes indicating switch problems
This OEM Frigidaire replacement is also compatible with Electrolux, Gibson, Kelvinator, and Kenmore models. Replace yours today to avoid expensive repairs down the road.
More
$61.56
- Compare At:
-
$73.26
- You Save:
-
$11.70
Genuine Whirlpool part
By: Whirlpool
Part Number: WP3399640
Dryer won't heat or overheats on low settings? A faulty temperature selector switch prevents proper heat control. Easy DIY fix in 10-15 minutes.
Do-It-Yourself Stories from Customers like You
Dead no power. Peter W. • Northfield , IL • January 29, 2024
APPs stellar videos got me started with confidence. Your parts diagram exactly match mine for my 28 year old Sears Kenmore Gas Model 110-97588210 (75882). Teacher at TMM Appliance convinced me to approach from the simpler, cheaper, easier to access parts inwards using the wiring diagram. I’ve designed products for Klein, Halo, and JUNO but am just an advanced electrical amateur. 3 parts totaling $110 and two hours and it runs and heats to spec. Even had time to vacuum out all over the lower...
Read more
More
$62.61
- Compare At:
-
$75.13
- You Save:
-
$12.52
Genuine Whirlpool part
By: Whirlpool
Part Number: WPW10285512
Fix erratic or unresponsive cycle selections with this laundry center rotary encoder switch. Mounts behind the cycle knob to restore accurate settings.
Do-It-Yourself Stories from Customers like You
Temperature control switch failed to cold only. Marilyn M. • Summerfield , FL • September 30, 2017
Replaced with a new one.
Read more
More
$83.44
- Compare At:
-
$99.29
- You Save:
-
$15.85
Genuine Frigidaire part
By: Frigidaire
Part Number: 242220208
Routes water from supply to filter housing inside your refrigerator. Replace if damaged, cracked, or leaking to restore a secure water path.
Do-It-Yourself Stories from Customers like You
Water leaking pooling up on the bottom of fridge and underneath Joe K. • Slingerlands , NY • December 15, 2014
Pulled shelves, filter, and filter housing, removed back panel, disconnected water line. Ran new line from water tank to valve, hooked up at filter housing. Cauked the hole where the lines go through.
Read more
More
$44.95
- Compare At:
-
$53.49
- You Save:
-
$8.54