Control Panel Lcd Parts

Genuine Whirlpool part

Refrigerator Defrost Timer

By: Whirlpool

Part Number: WP68233-3

Fix freezer icing and warm fridge temps by replacing a faulty defrost timer. Typical DIY repair takes 15-30 minutes with basic tools and a multimeter.

This part fixes the following symptoms

Freezer not defrosting

Do-It-Yourself Stories from Customers like You The refrigerator was operating in an unusual manner. The freezer would get abnormally cold even when set at the warmest temp on the dial. Then the refrigeration area was too warm. Greg T. • Boulder , MT • March 23, 2014

I took the bottom tray out of the freezer and found the coils iced up severely. I was reasonably sure the defrost timer was the problem and your tech said that was a good possibility. Ordered and replaced timer. (15 minutes) Problem fixed!!! Saved purchasing a new fridge at big bucks. We live over 40 miles from a service center so the cost of having a tech come out is astronomical. Thanks!!! Read more

$116.50

IN STOCK

Ships Today Guaranteed

Add to Cart

Genuine Whirlpool part

Thermostat (Bimetal)

4.6 (5)

By: Whirlpool

Part Number: WPW10584888

This thermostat is a temperature-sensitive safety switch that monitors heat and opens or closes the circuit at a set point. Replacing a failed thermostat restores reliable temperature protection and corrects issues caused by tripping or stuck contacts.

Monitors component/cavity temperature and trips at a preset limit
Opens (or closes) the electrical circuit to prevent overheating or activate cooling functions
Common symptoms: no heat or intermittent heating, unit won't start or shuts off during use, cooling/vent fan runs constantly or never turns on
Useful diagnostic clue: faulty thermostats may test open or stuck closed at room temperature

What's included: One thermostat Install notes:

Disconnect power at the breaker before servicing; if used in a microwave, be aware the high-voltage capacitor can retain a dangerous charge
Note wire locations; transfer one lead at a time and secure the thermostat in the original mounting position for proper sensing
Ensure clean metal-to-metal contact with the mounting surface; do not overtighten screws
After installation, restore power and verify normal operation

Do-It-Yourself Stories from Customers like You Temperature in fridge was too low James D. • Raleigh , NC • July 14, 2014

Replaced the thermostat Read more

$113.46

IN STOCK

Ships Today Guaranteed

Add to Cart

Genuine Bosch part

Dishwasher Control Board

5.0 (29)

By: Bosch

Part Number: 00676960

Fix a dishwasher that won't complete cycles or runs indefinitely with this control board. Controls all wash cycles and functions. 30-minute repair.

This part fixes the following symptoms

Touchpad does not respond

Do-It-Yourself Stories from Customers like You Stuck in 01 and wouldn't pump out & finish and shut off Harvey D. • Madison , CT • September 02, 2017

I ORDERED A NEW CONTROLLER BOARD. THE DIRECTIONS SHOWED HOW TO UNCLIP THE OLD BOARD BUT THE FASTENERS WERE ON THE LEFT SIDE NOT THE BOTTOM AS INDICATED ON THE REPAIR INSTRUCTIONS. AFTER REASSEMBLY THE DISHWASHER FUNCTIONED AS NEW. THNKS FOR THE INSIGHT. Read more

$229.95

IN STOCK

Ships Today Guaranteed

Add to Cart

Genuine Frigidaire part

Refrigerator Flipper Mullion Assembly

4.7 (3)

By: Frigidaire

Part Number: 241778811

Vertical flipper mullion assembly mounts to fresh-food door and pivots to seal center gap between French doors. Replace if cracked, broken, or rusting.

Do-It-Yourself Stories from Customers like You Water dispenser arm broken Harvey E. • Milford , CT • June 10, 2022

Replaced with new part. Read more

$193.95

IN STOCK

Ships Today Guaranteed

Add to Cart

Genuine Frigidaire part

Controller

4.8 (5)

By: Frigidaire

Part Number: 5304509229

The Controller is an OEM replacement part for Frigidaire ovens. It acts as the brain of the oven, managing and regulating various functions such as temperature control, timer operations, and user interface.

Symptoms of a bad controller include:

Oven not heating or maintaining proper temperature
Display or control panel not functioning correctly
Specific cooking modes or features not working as intended
Error codes or warning lights indicating a controller issue

Causes of a bad controller can include electrical faults, power surges, or component failure due to age or excessive heat exposure. Faulty wiring connections or damage to the circuit board can also lead to controller malfunctions.

This OEM replacement is also compatible with Electrolux, Gibson, Kelvinator, and Kenmore oven models.

Do-It-Yourself Stories from Customers like You Oven won't turn on Barbara N. • Scottsdale , AZ • August 24, 2019

I replaced the control board. Repair company wanted $395.00. I ordered the board for 140ish, 5 days later, 9 screws, 6 moduler plugs....working oven. The hardest part was pulling out the stove. Read more

$275.46

IN STOCK

Ships Today Guaranteed

Add to Cart

Genuine Lg part

Washer Noise Filter Assembly

5.0 (2)

By: Lg

Part Number: EAM60991301

This noise filter assembly is an electronic component that suppresses electromagnetic interference (EMI) generated by the washing machine's motor and control circuits. It helps prevent electrical noise from feeding back into your household wiring. Replace this part if your washer fails to start, shuts off unexpectedly, or causes interference with nearby electronics.

Do-It-Yourself Stories from Customers like You No power to start dishwasher Joe M. • Knoxville , TN • April 17, 2020

Checked circuit breaker to d/w first. Good. Went to website to see no power issues. Most all of them mentioned the noise filter being the problem. Removed filter from machine and found the corner melted where fuse is located. Ordered new filter, installed, and now have power to switches. All the information I found on the website really made this a easy job to get done. Read more

$77.48

IN STOCK

Ships Today Guaranteed

Add to Cart

Genuine Ge part

Range Control Panel Touch Pad Overlay

5.0 (10)

By: Ge

Part Number: WB27T11014

Adhesive-backed overlay that restores worn or faded control panel graphics on your range. Replaces damaged, cracked, or peeling faceplates for clean labels.

Do-It-Yourself Stories from Customers like You Faceplate Jose A. • El Cajon , CA • May 25, 2014

Got a replacement real fast delivery from you and exchange it fast and easy Read more

$31.95

IN STOCK

Ships Today Guaranteed

Add to Cart

Genuine Ge part

Dryer Timer Control

4.9 (12)

By: Ge

Part Number: WE4M189

Fix a dryer that won't advance, runs continuously, or stops unexpectedly. This timer controls cycle progression and power routing. 15-minute DIY repair.

This part fixes the following symptoms

Timer will not advance

Do-It-Yourself Stories from Customers like You Timer would not advance the time so dryer stayed on until manually shut off Mg C. • Simi Valley , CA • April 14, 2015

Just as the folks in the comments section said, I tested everything to make sure the timer had power which it did. I then tested with the OHM tester and saw that the switch was open when the timer was set to any drying cycle. So i changed the timer and voila! timer is functioning again. It was a very easy fix. Just pop the four screws out of the back of my timer panel on the dryer, detach all the wires, lift up on the little bracket that is holding the timer in place and twist it, and it... Read more

$137.95

IN STOCK

Ships Today Guaranteed

Add to Cart

Genuine Whirlpool part

Washer Main Electronic Control Board

4.8 (6)

By: Whirlpool

Part Number: WP8182689

This is the central control unit (CCU) that manages all of the washer's functions, including cycle selection, water fill, drum speed, and drain operations. It is a circuit board typically mounted inside the machine's control housing. Replace this board if the washer displays error codes, fails to start, stops mid-cycle, or if buttons and cycle selections are unresponsive.

Do-It-Yourself Stories from Customers like You F11 and eventually dl (door lock) error codes prevented proper operation of the kenmore he4t washer Daniel A. • Saint Johns , AZ • June 01, 2015

After unplugging the washer from the electrical outlet, the top of the washer was removed without a problem in order to allow easy access to the Central Control Unit (CCU) at the top of the back end of the washer. A cell phone was used to photograph the wiring layout and connectors plugged into the CCU, and then all connectors and the harness were carefully removed from the CCU without incident. Attempting to remove the old CCU, the plastic retaining clips built into the old CCU housing broke... Read more

$272.22

IN STOCK

Ships Today Guaranteed

Add to Cart

Genuine Whirlpool part

Washer Timer Control Assembly

5.0 (8)

By: Whirlpool

Part Number: WPW10243947

Fix cycles that won't advance or mixed-up wash settings with a new timer assembly. Moderately difficult repair taking 30-45 minutes with basic tools.

Do-It-Yourself Stories from Customers like You Timer needed replaced (maytag centennial) Jeremy H. • Cleveland , TN • November 14, 2014

My experience could not have been smoother. I called the repair guy just to see how much money I saved and I was shocked! I saved $123.00, thanks to appliance parts pro. Thank you so very much for your professional help, great prices & super fast shipping! From now on, when another appliance needs repair I'm going to you guys first. I'm spreading the word to every single person I know and posting it on social media as well. Thanks again, Jeremy Read more

$169.95

IN STOCK

Ships Today Guaranteed

Add to Cart

Genuine Whirlpool part

Coin Slide Interface

By: Whirlpool

Part Number: WPW10491734

The Coin Slide Interface is an OEM part for Whirlpool commercial washers. It is a component that allows users to insert coins or tokens to activate the machine and initiate the laundry cycle.

Causes of a faulty coin slide interface can include regular wear and tear, damage due to misuse or vandalism, or electrical component failure. These factors can result in issues such as coin rejection, incorrect coin counting, or the inability to start the machine using coins.

Symptoms of a Bad Part:

Will not start
Not washing properly
Timer will not set

This OEM Whirlpool part can also be used on Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper, and Kenmore/Sears brand appliances.

$57.39

IN STOCK

Ships Today Guaranteed

Add to Cart

Genuine Whirlpool part

Dryer Timer

4.7 (3)

By: Whirlpool

Part Number: 279737

Dryer won't advance through cycles or keeps running after finishing? This timer controls cycle sequencing and shutoff. Typical DIY repair in 15 minutes.

Do-It-Yourself Stories from Customers like You Timer not working on dryer. Michael S. • West Palm Beach , FL • February 08, 2020

Replaced timer. Took 15 minutes Read more

$191.71

IN STOCK

Ships Today Guaranteed

Add to Cart

Genuine Frigidaire part

Range Electronic Control Board

2.0 (1)

By: Frigidaire

Part Number: 316442119

Oven won't heat to set temperature or display shows error codes? This electronic control board manages bake/broil circuits and clock functions. DIY repair.

$208.63

IN STOCK

Ships Today Guaranteed

Add to Cart

Genuine Frigidaire part

Range Oven Control Board

5.0 (1)

By: Frigidaire

Part Number: 5304516117

This is an electronic control board that mounts inside the range and manages oven functions such as temperature regulation, bake and broil cycles, and display operation. It receives input from the touchpad or control panel and sends signals to heating elements and other components. Replace this board if the oven fails to heat, displays error codes, has an unresponsive control panel, or behaves erratically during cooking cycles.

Do-It-Yourself Stories from Customers like You Blown oven igniter went "poof!" with smoke at end of bake Peter M. • Salt Lake City , UT • March 04, 2022

So initial thought was bad bake igniter. I'bve replaced this before so I replaced it again and it wouldn't glow. Checked broil igniter and same thing, no glow. Checked voltage at molex connector for bake igniter and it went from 6.6v to 3.4v when triggered to glow -- well below the 120v expected. Ordered new clock/controller and overlay -- it shipped the next business day! Removed a handful of screws from the back panel to expose the clock/controller and removed/ replaced it with new... Read more

$203.64

IN STOCK

Ships Today Guaranteed

Add to Cart

Genuine Whirlpool part

Oven Control Panel Assembly

5.0 (1)

By: Whirlpool

Part Number: 5765M480-60

Control panel assembly for ovens. Houses touchpad buttons and display interface. Replace if cracked, unresponsive, or damaged from wear or impact.

Do-It-Yourself Stories from Customers like You Had an issue with the part that arrived based on shipping. Matt F. • Tampa , FL • November 24, 2017

They overnighted a new part without worry and any hassle. I like this approach. Read more

$272.95

IN STOCK

Ships Today Guaranteed

Add to Cart

Genuine Whirlpool part

Dishwasher Electronic Control Board

4.5 (2)

By: Whirlpool

Part Number: W10854215

Dishwasher won't heat, cycle, or start? A failed control board disrupts heating, wash cycles, and dispenser timing. Moderately challenging DIY repair.

Do-It-Yourself Stories from Customers like You Replaced control board on dishwasher Southern Auto I. • Lafayette , LA • August 26, 2018

Looked at Utube video. Was not as easy as it seemed to be. But I got it Read more

$151.51

IN STOCK

Ships Today Guaranteed

Add to Cart

Need help finding dishwasher parts?

Need help finding dishwasher parts?

Need help finding dishwasher parts?

Control Panel Lcd Parts

Refrigerator Defrost Timer

Thermostat (Bimetal)

Dishwasher Control Board

Refrigerator Flipper Mullion Assembly

Controller

Washer Noise Filter Assembly

Range Control Panel Touch Pad Overlay

Dryer Timer Control

Washer Main Electronic Control Board

Washer Timer Control Assembly

Coin Slide Interface

Dryer Timer

Range Electronic Control Board

Range Oven Control Board

Oven Control Panel Assembly

Dishwasher Electronic Control Board

Appliance Type

Brands