Kitchen Vent Parts

To access the tub seal, complete disassembly of the washer unit was involved, including removal of the dryer unit on top in order to pull out both tubs. The motor and bearings must also be removed as well from the underside of the outer tub. Read more

Model# MAV7257AWW Maytag Atlantis Washing Machine. Repairs were fairly easy along with the videos appliancepartspros offers on their website. Parts also came with instructions on how to install. Other videos were available on You Tube. The only part difficult to install was Thrust bearing kit - make sure when installing to pull down on shaft so washer and e-clip will fit. Another note, you can get a pulley for your replacement motor pulley on eBay and Maytag.com. Just pay close attention to... Read more

Simply open the top of the washer by inserting a putty knife (watch YouTube ) and then the front panel by removing two bottom philips head screws on the front. The whole front panel comes right off. Using pliers the spring clams holding each hose, they come off and each hose is replaced. The drain one was only leaking but since it has open I changed both and even the drive belt. Whole job less than 1 hour. BTW parts arrived next day! Read more

Replaced vent hose and connectors. Next year the sliders will also be replaced. I am a 76 year old woman completely on my own. The web site was easy to use when ordering the necessary parts. I did need to enter the model number of the unit but nothing else was needed to find the parts. I am very well pleased with the shopping experience and quick delivery of the items. Thanks! Read more

Attached drain hose extension and it more than reached the drain. Read more

I replaced the part, using Youtube as a guide. The hardest part was thawing out the freezer. Read more

Our washing machine door boot seal was getting moldy and causing odor problems. Cleaning tablets and bleach weren't helping so it was time to be replaced. While I had the top and front off I changed all the hoses that could be collecting soap scum and mold, all other wetted parts were removed and washed. The video on the door boot seal, and inlet valve assembly were extremely helpful in understanding how these parts are removed and reassembled. Although the door boot seal is the most visible... Read more

I figured it had to be the flume; changed the flume and hose, mounting screws Read more

I removed the top. I took a screwdriver and removed the plastic piece where the inlet hoses go. I twisted and removed the white pipe which had an arrow indicating how to (lock) it. Now I can remove the hose clamps that hold this hose in. The old hose has a hole, I don't know why. new hose goes in. tighten clamps. put everything back together. Read more

Removed the back of the washing machine, removed the hose and installed the new one easy peasy... Read more

Replaced Read more

Unplug from electric socket. Pulled the washer away from the wall. Have a container ready to catch any water remaining in the hose. Remove the hose from the drain in the wall and drain into container. Unsnapped the hose from the guide on the back side of the washer and removed the plastic piece around the hose on the outside of the case where the hose enters the inside of the case. Took off the front of the case, removing two screws from the bottom of the front and two from the underside of... Read more

After researching on the internet, I decided replacing the wave guide cover would be much cheaper than replacing the microwave. Plus I couldn't even find one that worked with the existing trim kit. Had a bit of difficulty removing the old cover, but the folks at Appliance Parts Pro answered my email question within 24 hours. I received the replacement part a day or so later. GREAT CUSTOMER SERVICE! Thanks! Read more

I ordered the drain extension kit and the hose connector kit. Read more