Yard Machine Small Engine Float Bowl Gasket Parts

Repair was easy. The new part didn’t fix the problem. The feed shutoff valve worked (produced water) however, inside it’s rubber pieces broke off and clogged the feed line. Need a new valve but the new parts are typical wearables so I kept them in. The two parts I purchased from Appliance were at my door within 24 hours. Great service!! Read more

Replacing the inlet valve solved the problem. The old valve was somehow clogged with white sediment. I probably could have taken it off and cleaned it out if I'd known, but replacing the valve was much easier. Took about half an hour to repair. Video walk through was extremely helpful. Great to have a working dishwasher again! Read more

About a year ago my dishwasher during a cycle was emitting a horrible plastic burning smell. We stopped it mid-cycle, cleaned it out and tried to run a few more cycles after that and realized it wouldn't drain so it sat in my kitchen broken for a year. I finally got so fed up with washing dishes by hand that I took the whole dishwasher apart. Confirmed there were no blockages in any of the hoses etc. when it still didn't work I googled the problem, found this website and found that it must be... Read more

Replaced the upper and lower felt strips and drum glides. Dryer running much quieter and not tearing clothes. Read more

I watched the video on this website and did the repair Read more

Ordered the part via the model number. Removed the old gasket (just pulls out of the indentations and cleaned the channel for the gasket. Pushed into the channel and no more frost forming in the freezer. Read more

Replaced it. Read more

Replaced door gaskets with new ones Read more

Replaced both the door gasket * defrost timer and everything works great. Read more

I searched online for replacement parts and Appliance Parts Pros had the part in stock. Before I ordered the part, I watched the video to see if I could handle the repair. I ordered the part and soaked the gaskets with warm water in the tub. The old gaskets had a much simpler setup, so no cutting was involved. I simply pulled the old gasket out of the track without issues, and installed the new one with finger pressure. Per the video, I took both doors off. However, due to the design, I could... Read more

Just like the one's I have worked on for 30 years for Whirlpool. Read more

The symptom was suds and water on the floor at the left front of the dishwasher within the first five minutes of operation. Examination of the seal inside the door showed it was warped and pushed up into the door out of place. Once disassembled we found a tear in the seal, severe warping, and the material was sticky and slimy rather than flexible. I found a video of the disassembly that was very helpful. It is necessary to pull the dishwasher out of the cabinet but my installation had no top... Read more

Left new gasket on the table overnight so it could stretch out. Removed the door. Temporarily replaced it with plastic and tape. Pulled off old gasket. Cleaned surfaces with decreaser and wiped dry with paper towels and alcohol. Inserted new gasket. Replaced door. Read more

• Will not fill with water

Cycle would complete but dishes weren't clean (not even really wet) and soap wasn't dissolving. Could hear fill at start but maybe not spraying or filling again in cycle. Thought it was the control board, but actually this was not the error. Replaced the control board and same problem arose, only new control board version actually stopped cycle with message that dishwasher couldn't fill. Looking underneath the pump had somehow become dislodged from the bottom of dishwasher and was laying on... Read more

Removed water out of basin, down to the last inch.. Watched water rise slowly, and felt temperature, warm. This told me it was supply water. Ordered replacement part, two days just as mentioned, Removed as per video. Also choose to replace the waste line check valve, to affordable not too. Working great, except the wood floor not so happy with. One thing at a time. Thanks Read more

The freezer door on my 12-yr old GE side-by-side refrigerator/freezer would not stay completely shut resulting in temperature variations and ice buildup from outside humidity seeping into the freezer compartment. These problems were exacerbated by the fact that this appliance is located in my garage in the heat / humidity of the Atlanta, GA area. I applied a thin layer of petroleum jelly to the gasket which improved the seal but did not completely solve the problem. I discovered that... Read more